The streetlights are putting out a lot more power (and thus heat), and thus need much better thermal management, which it appears they don't actually have.
My theory is that they test them in lamps upright. I’ve noticed much higher failure rates with fixture based and inverted bulbs.
The thing is, as bad as the waste is — I'd much rather chuck out LED bulbs than CFL/FL.
I've had 2 led failures since I went fully led 8 years ago, one went soon after purchase and looks like a manufacturing defect, so that leaves one that could potentially be heat. Most of them are no names, most recent are Phillips though.
Heat is really ungood for LED's and the drive circuits[1]. With a recessed fixture there is no place for the heat to escape.
[1] I've noticed excepting electrolytic caps electronics that doesn't get warm, basically lasts forever.
Or did it. I noticed that if you keep it on long enough after it turns off it will come back on. I think the fuse or something gets heated and it stops until it cools.
Really? As an anecdatum, I replaced most of the lights in our house with cheap LED globes a few years ago and so far not a single one has failed. Maybe I'm just lucky. CCFL lamps, however, have been terrible while using 3x the power.