News for hackers. Stuff that matters.
Re:Thelio – System76 by isantop on Monday November 05, 2018 @01:52PM (#18384833)
System76 Engineer here, who did a lot of work on the ID for Thelio. The veneer actually has a pretty superb minimum radius, depending on which direction you bend it. Bending with the grain for our particular veneer lets you bend around a 1/8" radius (about 3mm) pretty reliably. That's reduced a bit in our case since the finish is applied first (part of a cost-reduction), which limits it a bit, but Thelio uses corners that are pretty close to a 20mm radius, so that's not really a limiting factor here.

You can actually cut the stuff with a normal pair of paper scissors. It's pretty wild stuff.

There are no comments on this comment yet.