News for hackers. Stuff that matters.
Re:Thelio – System76 by fermienrico on Saturday November 03, 2018 @12:28AM (#18368696)
I was just trying to make a general point in terms of the ID thought process that you start from functional/engineering needs and work outwards from it.

In the case of System76, they had to bend wood vaneer (poor bend radius) which probably added additional expense to the manufacturing process.

Re:Thelio – System76 by isantop on Monday November 05, 2018 @01:52PM (#18384833)
System76 Engineer here, who did a lot of work on the ID for Thelio. The veneer actually has a pretty superb minimum radius, depending on which direction you bend it. Bending with the grain for our particular veneer lets you bend around a 1/8" radius (about 3mm) pretty reliably. That's reduced a bit in our case since the finish is applied first (part of a cost-reduction), which limits it a bit, but Thelio uses corners that are pretty close to a 20mm radius, so that's not really a limiting factor here.

You can actually cut the stuff with a normal pair of paper scissors. It's pretty wild stuff.