News for hackers. Stuff that matters.
Re:Macbook Pro frying USB peripherals by konschubert on Tuesday May 01, 2018 @04:58PM (#16971536)
What is SMD?
Re:Macbook Pro frying USB peripherals by jburgess777 on Tuesday May 01, 2018 @05:06PM (#16971641)
Surface Mount Device. The name given to components which are soldered directly to the surface of the PCB (printed circuit board). SMD devices are very common now and replace older components which had legs (or leads) which had to pass through holes in the circuit board, also known as "leaded components" or through-hole.
Re:Macbook Pro frying USB peripherals by wlesieutre on Tuesday May 01, 2018 @05:12PM (#16971710)
Adding to the other comments, this is in contrast to "through hole" components with leads that poke through holes and are soldered to pads on the reverse side of the board.
Re:Macbook Pro frying USB peripherals by graystevens on Tuesday May 01, 2018 @05:02PM (#16971588)
Re:Macbook Pro frying USB peripherals by diabeetusman on Tuesday May 01, 2018 @05:03PM (#16971602)
Surface Mount Device; sort of the opposite of through-hole, they're both soldering and electronics mounting methods.

https://en.wikipedia.org/wiki/Surface-mount_technology

Re:Macbook Pro frying USB peripherals by gsteinb88 on Tuesday May 01, 2018 @05:02PM (#16971590)
Re:Macbook Pro frying USB peripherals by nasalgoat on Tuesday May 01, 2018 @05:02PM (#16971585)
He probably means SMT - surface mount technology.
Re:Macbook Pro frying USB peripherals by dsr_ on Tuesday May 01, 2018 @06:43PM (#16972424)
SMT is the technology; individual devices are SMDs, or "surface-mounts" or "surface-mounted".

Beyond terminology, SMD are much harder for an individual hobbyist to desolder, replace and resolder than through-mount, but they are easier for pick-and-place machines to deal with.

If you're prototyping a simple device, you can start with a breadboard -- no soldering. Then you can get a circuit board printed to your spec and use the same components, for low-volume work. If you need high-precision placement, you will probably need to transition to surface-mount.

Re:Macbook Pro frying USB peripherals by jonhendry18 on Thursday May 03, 2018 @01:58AM (#16983654)
"Beyond terminology, SMD are much harder for an individual hobbyist to desolder, replace and resolder than through-mount, but they are easier for pick-and-place machines to deal with."

And SMD are smaller, allowing smaller circuit boards and smaller devices.