However, the 18650s have no internal electronics to prevent any charging mishaps.
- Overcharge protection (prevent charging past the max voltage, probably ~4.2V but intentionally shrinking this window might prolong cell life)
- Short circuit protection (Like, a fuse? Would a PTC one work?)
- Limit charge current (0.5-1C for LiPos, 5-10C for LiCaps, etc)
- Undercharge protection; prevent discharge past a 'low voltage' value and (ideally) permanently disable cell or severely limit charge rate if voltage drops below the minimum safe value.
- (Ideally) Balance voltage between individual cells.
I believe you can get ones which do have this - e.g. https://www.amazon.co.uk/Canwelum-Protected-Lithium-Battery-...
"Reliable 18650 Battery: Integrated with protective board, avoiding overcharge and discharge, protecting your led torches or head torches. "
There was also this project on hackaday to make a "topper", but it would not work w/ leaf spring battery connects because of the increase in height.
I guess the higher the current the better you vaporize the material?
The higher this limit generally the "safer" the battery performs in high drain operations like actually vaping the ecig, and this means that not only can you go to higher power levels, but that lower ones will also generally not heat the battery as much, and reduce the risk of thermal runaway or venting.
Take a variable power mod using power regulation set at 50w (a relatively common power setting for enthusiast/higher end vapers but that can be a daily driver), with an atomizer at 0.18ohms resistance and a Sony VTC5 18650 as the battery with 2600mAh capacity and a sustained safe current amperage limit of 30A.
To get 50w you will need to apply 3.00V / 0.18ohms or 16.67 amps. If you for instance choose a poor battery re-wrap, like this Cylaid 3500mAh advertised at 10amp continuous discharge, which is actually just a "re-wrapped" battery which can only sustain 8 amps, you would be in dangerous territory where the battery would likely get much hotter than a quality one and have higher potential for thermal runaway/venting.
https://www.e-cigarette-forum.com/forum/threads/cylaid-10a-3...
The most interesting thing you'll notice is an inverse relationship with capacity in mAh and continuous discharge in amperage. You can either have a higher capacity battery with lower continuous discharge current, or a lower capacity battery with higher continuous discharge current, not both.
This holds true even if the coil is 0.5Ω
https://www.e-cigarette-forum.com/forum/blog-entry/list-of-b...