Like some other commenters here, if I need a color print, I just walk down the street and have a professional printer do it for one or two dollars for a huge glossy or matte high-resolution print. If you do the math, it's cheaper to do this regardless of how much you print -- per page, a consumer inkjet is more expensive than a professional print, and looks worse. There is no point.
(I can even just send it online, and walk over and get it sometime later when it's already done.)
http://www.rihac.com.au/ciss-systems-c-26.html
We have a couple in our co-working space.
Probably the best woot I've ever bought.
We got an HP Photosmart 8250 or so 3-4 years back. IIRC it was pretty much the most expensive A4 inkjet from HP at the time, but even that was only 2-3x as much as a mid-grade consumer printer. In any case, unlike most printers, it uses separate tanks for each colour of ink, and the print head isn't integrated into the cartridge. It makes a huge difference: the jets don't get blocked as they're designed to last. They also seem to be more precise, and you only replace the ink that's actually used up, and because the cartridges are "dumb", they're cheaper. Not quite cheap as such though, and bigger cartridges would be nice.
As for original manufacturer's ink vs third-party: in my experience, the HP stuff ages much better (especially when exposed to sunlight), everything else is probably subjective.
Not to mention I prefer the quality of laser for B&W and that's all I do anymore.
- You can get an inkjet printer for free (not difficult, people throw working printers away all the time)
- You can invest the money conservatively at a high, but not extraordinarily high rate
- You print very rarely
My current inkjet cartridge cost $50. I've had it for two years, and it's about 60% full according to the display on the printer (which, admittedly, might be lying). That's a savings of about $250 over buying a cheap laser printer. Assuming that the laser printer will last indefinitely with no further expenses (hey, it very well might), I need to get about a 1/5 ROI on the $250 over the expected lifetime of the ink (5 years, but assume the software lies and call it 4) to break even. That takes about a 4.7% interest rate. If you can invest the money and make about 5%, it's actually cheaper to buy the ink. I could do this, by "investing" it in paying student loans more quickly, so it makes sense.
Of course, if you print a lot, it's absolutely silly to use an inkjet for it.
It's all about the technology, but I wouldn't generalize to 'professional' and 'consumer'. The base technology, laser printing, allows for high speed, long life of cartridge and printer, and other benefits.
i.e. look at the ssd/flash drive manufacturers; some of them may advertise huge shock resistance. Sure, it is true, but they didn't have to do anything about it. It's all about the underlying technology of mounting solid state parts on the PCB, and surface-mounted parts even further, that provides the benefits we receive. It's all about the technology; the division into 'consumer' and 'professional' is superficial.
Although we did have to put tape on the sides so the printer would stop complaining. It ran on that "empty" cartridge for another 2 months ;-)
I'm just going to get another laser printer once its on its last legs.
Several hundred pages in, I'm still on the original cartridges.
http://www.okidata.com/mkt/downloads/B4250_B4350Series.pdf
I paid about €250 for it (which then was < $300) and not only does it print higher quality and faster, after printing thousands of pages (I'd guesstimate 5000 pages), it still hasn't run out of its initial toner cartridge, and the prices I've seen for when it does are about €25.
With printers, as with much in the electronics world, it makes sense to buy the lowest end professional device rather than futzing around with consumer-grade stuff.