News for hackers. Stuff that matters.
Re:Sleep Debt by tomrod on Sunday February 19, 2017 @09:04AM (#13679729)
If you don't have control over the heating being on, a cracked window goes a long way. My (very, very dated) dorm my freshman year ran the heat 24/7, often up to 85 degrees. Cracking a window kept it a pleasant 72 degrees. Wasteful? Absolutely. But worked with the constraints given.
Re:Sleep Debt by Eridrus on Sunday February 19, 2017 @09:23AM (#13679828)
Sadly it's hard to get a precise temperature this way when it's 30F oitside. Waking up cold isn't much better than waking up hot.
Re:Sleep Debt by germinalphrase on Sunday February 19, 2017 @11:26AM (#13680419)
I was once gifted an electric mattress pad. Once I got over my own eyerolling it turned out to be pretty amazing. I was lying in a drafty, poorly insulated farmhouse in Wisconsin at the time (so maintaining a comfortable sleeping temp. was difficult). The ability to warm up the bed before getting in was very helpful (as is being able to "dial in" sleeping temp. separately from the thickness of blankets).
Re:Sleep Debt by randomdata on Sunday February 19, 2017 @09:59AM (#13680000)
This is Hacker News though. A thermostatically controlled actuator, or similar, will fix that up.
Re:Sleep Debt by Eridrus on Sunday February 19, 2017 @10:56AM (#13680237)
Yes, but I also value my time.

It's a possible project, but you would need to not only have something that opened and closed, you would need a fan system to drive the air, and you would need to have it be thermally insulated when closed, and unless you have a very conservative cooling algorithm you would probably want a heating system to deal with the room getting too cold because the room itself is not thermally sealed.

It ends up being a DIY air conditioner/heater, which I'd rather just buy.

Re:Sleep Debt by fghgfdfg on Sunday February 19, 2017 @01:26PM (#13681080)
I think you're thinking a little too big. All I think that is really being suggested is an automatic window cracker/closer.

If the goal is just to maintain a temperature I don't think you need to go to most of the lengths you mentioned. You have a window that is currently adequately insulated when shut. This is intended for maintenance so no need for a fan to speed things up. However the room is getting too hot now will suffice to heat it back up if needed, but again being slow means it shouldn't overshoot badly either.

It still may not be worth your time, but if just cracking a window would be sufficient cooling for most of the year it could be.

Re:Sleep Debt by CalRobert on Monday February 20, 2017 @04:12AM (#13685718)
A moment's thought leads me to think you could use something like this: (temp-controlled plug bar, basically) http://www.homebrewtalk.com/showthread.php?t=536763 Attached to a motor /servo (depending on your window) that will turn on or off at a given temperature. Have a switch on the window which cuts off/enables the power when the window is open or closed at the desired max/min.
Re:Sleep Debt by trentmb on Monday February 20, 2017 @01:06AM (#13684737)
Crack window, wedge towel in leaving a small inlet for cold air.