Re:Chisel: Constructing Hardware in a Scala Embedded Language
by nickpsecurity on Sunday July 26, 2015 @10:38AM
(#9951152)
Ok that all makes more sense. One of my potential flows was actually having the amateurs build lost of functionality (eg accelerators, device protocols) with HLS tools that a hardware engineer could finalize for FPGA. Would save on the rare labor. What do you think of that model vs exclusively leveraging HW people?
Far as ASIC's, I'd just get HW people, haggle on the tools, use free one's if possible (see Qflow), and do a MPW run for prototyping/production. eASIC's 90nm maskless stuff, potentially. Start it on 180nm-350nm, though, as there's lots of cheap masks and fab capacity there.
Re:Chisel: Constructing Hardware in a Scala Embedded Language
by gluggymug on Sunday July 26, 2015 @11:33AM
(#9951311)
What do you think of that model vs exclusively leveraging HW people?
Sounds good.
Cheap fab I am not sure whether the costs make sense. Depends on the project I guess. I don't have a lot of experience with those manufacturing processes.
Unfortunately there is no infrastructure for you to build onto. It's like a blank slate. All the I/O needs to be done right. It's very seldom just instantiating wires unless your design is blazingly simple. And if it were simple you wouldn't need an FPGA in the first place. A generic coprocessor would kick most FPGAs butts.