Wood can be conductive depending upon its water content.
Even better, don't poke around in an amp unless you have at least a basic knowledge of electronics. The voltages in there are in the range of 500V, and electricity doesn't respond like you're used to at that level (DC switches, for example, need to be much bigger to resist the arcing at those voltages).
And, while its cool to see someone hack, the amount of damage EVH did to perfectly good guitars (some of them beyond that) is legendary. Learning even a little about what you are hacking goes a long way.
My inside-an-amp tinkering only goes as far as pulling 2 of the el84s from a Classic 50 to half the output. It was still stupidly loud for home use though!
I know some amps supposedly discharge if you hit the standby and power switches at the same time, but I wouldn't like to trust that
What I believe is safe enough for me to do... but not so safe that I'd recommend anyone else do it... is to measure the voltage between the high voltage supply and the ground in the amp, and see what you'll be getting if you touch it. If it is more than a volt or so, then connect a 10K resistor between the HV and the ground.
That said, if you don't understand why you should do that (or why taking life and death electronics advice from strangers in a comment thread is a bad idea), then you might want to just not get around in there, because you can lose fingers or even die if you don't know what you're doing.
:D Go circuit bend a speak and spell or something, and leave tube amps to folks who want to know more whys before touching stuff. :D