Rotaries, properly cared for, are a reliable engine with fantastic power delivery and small size. It's a shame they are plagued with high fuel consumption which limits their usefulness in anything but sports and racing applications.
If you read the article this is not a conventional wankel rotary - the rotor design looks like a wankel housing, so it's flipped around.
I can't imagine a technology like this is that well suited to constant and relatively low power delivery.
on a pre-89 that (factory) redline is at 7k, 8k on 89-. RX8s you have to hit 9k.
This does make it hard not to speed in an RX7, especially if you've done a little bit of work to it - not so much in the RX8.
They're also ideal for alternative fuels like natural gas because the combustion chamber is in a different location to the intake/compression, which makes it easier to limit uncontrolled ignition (detonation). And the oil injection makes them suitable for adding specific lubricants to the intake charge.
On the topic of giving engines a good dose of WOT and revs, all modern direct injection cars need this as the loss of port injection means that the intake runners and valves are no longer given a constrant stream of fuel to clean them. As some exhaust gases enter the intake runners when valves overlap, over time this leads to massive carbon buildup in the intake side. Google some pictures of Audi engines with carbon deposits - makes your eyes water.
So if you have a modern direct-injection petrol injection make sure you give it a good 'italian tune up' on frequent occasions as well.
Well, they were given dispensation to run 170kg lighter than any other car in the class (830kg v. 1000kg). It's likely that that made the deciding difference in their win.
Also, it's worthwhile remembering a lot of the fuel efficiency problems with rotaries are avoided by running at a constant, relatively low RPM. For a generator motor, they make a hell of a lot of sense. Sealing the chamber is also a lot easier at a constant RPM, which should help with oil consumption and reliability.
1. http://en.m.wikipedia.org/wiki/Diesel_locomotive#First_funct...
I believe the carbon residue acted like graphite. The hardness of the components was so much higher than metal that it was like comparing the lifetime of ceramic bearings like silicon nitride (Si3N4) to metal bearings.
IIRC, it wasn't feasible to make large parts with available sintering tech.
This rotary engine being smaller, perhaps its feasible to use ceramics.
"Where the rotor holds the seals in a normal Wankel, the housing does that job in the X1 engine. This allows significant reduction in oil consumption over a regular rotary motor."
http://www.popularmechanics.com/cars/a8174/liquidpistons-hyp...
Something about this design smells to me but I can't quite pinpoint it yet.
Reminds me of the "orbital engine" out of australia last century that had some challenges it couldn't overcome. There are lots of other attempts to make different engines.
http://en.wikipedia.org/wiki/Orbital_engine
Alternative engines are always interesting though, and who knows?
While the rotary did won Le Man 24 hr endurance race, it is still plagues with problem. These problems isn't because Pistons are better but because Pistons had tons of time refining it. Rotary so far have been neglected and it seems like EV/battery technology will be the future while hybrid is just an intermediate step between oil and electric.
Another interesting engine that GM tried was Turbine, jet engine for cars. It sound like a vacuum cleaner.