News for hackers. Stuff that matters.
Re:Building a 3D Printed Electric Jet Powered Snowboard by kposehn on Wednesday April 08, 2015 @04:29PM (#9343715)
How would a gas turbine be safer? Much more heat, flammable fuel, so I'm curious as to the reasons.
Re:Building a 3D Printed Electric Jet Powered Snowboard by toomuchtodo on Wednesday April 08, 2015 @04:34PM (#9343749)
Depending on the fuel, gas turbines can be much safer. The current and voltage he's working with is fairly dangerous for close contact, where it takes a great deal of effort to ignite kerosene or diesel fuel in an open air environment.
Re:Building a 3D Printed Electric Jet Powered Snowboard by kposehn on Wednesday April 08, 2015 @04:58PM (#9343935)
Ah, ok. That makes more sense now.

Still, I would expect the massive heat output of a gas turbine to be another danger as well. You are, after all, spitting extremely hot gases out the back, which could pose a great danger to anyone behind and might also melt a large amount of snow. Probably depends greatly on the method of mounting it though...

Re:Building a 3D Printed Electric Jet Powered Snowboard by erobbins on Wednesday April 08, 2015 @06:20PM (#9344483)
It wouldn't, and it would suck fuel like crazy. Fans aren't optimal for low speed thrust.. turbojets even less so :) 2 fans would be much better than 1 jet.
Re:Building a 3D Printed Electric Jet Powered Snowboard by trhway on Wednesday April 08, 2015 @06:54PM (#9344679)
not safer, though with [bigger] gas turbine you can get something like this :

https://www.youtube.com/watch?v=XJARrc40imk

or with bigger propeller : https://www.youtube.com/watch?v=C_UtPmb3Z-o (in the San Carlos museum btw)

Re:Building a 3D Printed Electric Jet Powered Snowboard by savrajsingh on Wednesday April 08, 2015 @06:16PM (#9344454)
Jude is a part-time comedian. :) He was just kidding.