Re:Boiling point: redesigning the kettle for the 21st century
by rsfern on Tuesday February 17, 2015 @01:07AM
(#9060901)
I think it'd be pretty difficult to do for arbitrary liquids, because i imagine there would be some non-trivial temperature gradients. You'd probably have to account for the heat capacity and thermal conductivity of your soup to get it close to right. Simpler and cheaper to just use an old-fashioned thermocouple that clips onto the mug wall or something.
Re:Boiling point: redesigning the kettle for the 21st century
by brianshaler on Tuesday February 17, 2015 @01:17AM
(#9060918)
That's a good point. Perhaps an infrared sensor pointed down from the handle would give you meaningful data.
Re:Boiling point: redesigning the kettle for the 21st century
by iopq on Tuesday February 17, 2015 @12:46AM
(#9060846)
because it would be extremely hot if it's inside the rod, giving the wrong temperature
so it would be useless because all of the hot liquid is around the rod, while the coldest liquid is the farthest from the rod
Re:Boiling point: redesigning the kettle for the 21st century
by brianshaler on Tuesday February 17, 2015 @12:56AM
(#9060872)
Would it be the wrong temperature if what you want to know _is_ the rod temperature?
I would agree the liquid surrounding the rod vertically would also be above the average liquid temperature. It seems like you could use a different material and shape farther up to get a more accurate liquid temperature.
Different substances have different temperature restrictions, but it seems like for rapid heating, you could target 100C at the end of the rod but reduce power as the liquid (perhaps monitored by a second thermometer higher up the rod) approaches 70C, or whatever your preferred temperature is.