News for hackers. Stuff that matters.
Re:Apple Lightning Connector Serial Access by userbinator on Saturday February 14, 2015 @06:56AM (#9049446)
Basic details about the ID/authentication protocol have been known for a while: http://www.eevblog.com/forum/oshw/oshw-apple-lightning-conne...

It'd be interesting to see where this leads. I'm willing to bet that the Chinese have RE'd most of the protocol, but have kept the secrets to themselves. (If you're curious to learn a foreign language, and have some interest in electronics, learn Chinese - there is a lot of stuff on that side of the Internet that can't be found in English. The whole "Gongkai" ecosystem that bunnie writes about, for example: http://www.bunniestudios.com/blog/?p=4297)

That "BRICK_ID" signal sounds a little ominous...

Re:Apple Lightning Connector Serial Access by peatmoss on Saturday February 14, 2015 @12:09PM (#9050099)
Ten-years-ago me would have been shocked at the notion that cables now contain computers. I feel like I've just barely come to terms with the idea that computers are actually collections of computers, of which some are controlled by their owners.
Re:Apple Lightning Connector Serial Access by foxhill on Saturday February 14, 2015 @05:02PM (#9050927)
your comment reminds me of this -

http://spritesmods.com/?art=hddhack&page=7

it makes you wonder how many Linux capable processors actually make up the computer you run..!

Re:Apple Lightning Connector Serial Access by voltagex_ on Saturday February 14, 2015 @08:17AM (#9049572)
Searching https://www.google.com.au/search?q=iBoot+for+n53,+Copyright+... shows that this page could be the only place that the boot messages have been logged. Wonder if this will lead to new jailbreaks?
Re:Apple Lightning Connector Serial Access by comex on Saturday February 14, 2015 @02:33PM (#9050526)
Not directly; iBoot outputs stuff to serial, but I don't think it accepts commands over it - or if it does, it would be the same locked-down interface you get over USB. (I should check which one.) However, serial over the old 30-pin connector has in the past assisted jailbreak-related software by making it easier to do low-level debugging.
Re:Apple Lightning Connector Serial Access by Yetanfou on Saturday February 14, 2015 @07:00PM (#9051215)
Well, there is this line in the output:

    Delaying boot for 0 seconds. Hit enter to break into the command prompt...
...which gives at least the impression of there being a command prompt. As to how it would register a hit on that enter key remains to be seen, of course.
Re:Apple Lightning Connector Serial Access by scintill76 on Saturday February 14, 2015 @07:09PM (#9051251)
I wonder if "0 seconds" means it's disabled, which would make sense for a consumer build.
Re:Apple Lightning Connector Serial Access by undrwatr on Saturday February 14, 2015 @10:19AM (#9049838)
Interesting so first the device reads the lightning connector itself to configure the pins which is a plaintext exchange? Then the mfi handshake is done separately using a chip in the accessory? He didn't say exactly what had to be done to activate the debug UART. Presumably once he determined the ids for debug accessory there was no mfi handshake required or the mfi chips he had were able to pass the handshake. Surprising that the debug functions wouldn't be protected by a different mfi key.
Re:Apple Lightning Connector Serial Access by timbuktu on Saturday February 14, 2015 @08:08AM (#9049549)
Does the C in USB Type-C (USD 3.1) relate in any way to the the C in 'C10C'? I mean soon there's going to be a lightning pin at one end and a USB Type-C at the other end. I also guess engineers from both sides must already be talking to each other.
Re:Apple Lightning Connector Serial Access by techrat on Saturday February 14, 2015 @01:00PM (#9050229)
No. Due to the way that Apple designed the Lightning connector, it's not capable of higher USB specs than 2.0. Limited pins and the connector inside the socket only contacts one side at a time.
Re:Apple Lightning Connector Serial Access by foxhill on Saturday February 14, 2015 @06:34AM (#9049406)
i'm always blown away when people reverse wire protocols like this - i don't even know where i'd start to do this sort of thing..

could this be used by apps on the device in any way?

Re:Apple Lightning Connector Serial Access by nitrogen on Saturday February 14, 2015 @07:05PM (#9051231)
Start by learning about logic analyzers: https://en.wikipedia.org/wiki/Logic_analyzer

You can get cheap (but slow) analyzers as open hardware, such as the Bus Pirate ( https://en.wikipedia.org/wiki/Bus_Pirate ). Also check out the Saleae USB analyzers ( https://www.saleae.com/ ).

Re:Apple Lightning Connector Serial Access by swamp40 on Saturday February 14, 2015 @02:25PM (#9050505)
Does anyone know the advantage of using two different pin outs on either side of the connector, instead of simply reversing one side?
Re:Apple Lightning Connector Serial Access by tcas on Saturday February 14, 2015 @03:10PM (#9050644)
As far as I know the differential lanes are swappable. They each have an identification channel assigned to them, so the combinations are (ACC0, Data1, Data2) and (ACC1, Data3, Data4). Keeping in mind that the function of each lane is found once it's plugged in the cable becomes fully reversible and routing inside the connector is simpler.
Re:Apple Lightning Connector Serial Access by thrownaway2424 on Saturday February 14, 2015 @02:47PM (#9050572)
Well done, impressive willingness to deal with chip-scale BGA soldering and spend the time to reverse the wire format.