News for hackers. Stuff that matters.
Re:3D Printer Shootout – $600 Printrbot vs. $20,000 UPrint S... by yaddayadda on Friday February 06, 2015 @12:46PM (#9010313)
According to Hansleman:

> My 0.2mm print took about 7 hours

> Brandon said it took 8 hours and 22 minutes.

So in this case, the $22,000 printer took ~17% longer.

Re:3D Printer Shootout – $600 Printrbot vs. $20,000 UPrint S... by spott on Friday February 06, 2015 @01:06PM (#9010464)
To do 4 - 8 times the work... (depending on how you think about it).

In order to create a "bar" .2 mm on a side, the .1mm printer needs to lay down 4 lines, while the .2 mm printer only lays down one.

Re:3D Printer Shootout – $600 Printrbot vs. $20,000 UPrint S... by disposablename on Friday February 06, 2015 @02:35PM (#9011052)
Layer height and extrusion width are separate settings, if the extrusion width is the same, it's only twice as much head travel, not four times. Extrusion width is around .4mm on most FDM printers.

You can't really call it more work either, since the resulting volume is identical.

The only thing that's different between the two prints is Z resolution, and that's a factor of 2 difference.

Re:3D Printer Shootout – $600 Printrbot vs. $20,000 UPrint S... by mcguire on Friday February 06, 2015 @01:03PM (#9010441)
The point being that the commercial printer is doing it at twice the linear resolution.