Re:Router can power your devices wirelessly from 15 feet away
by andruby on Friday January 09, 2015 @08:44AM
(#8862166)
2.4Ghz is only used for the bluetooth communication, not for the power transfer. That happens at 5.7-5.8Ghz.
"What are the RF spectrums being used by WattUp?" [1]
- 2.4GHz (Unlicensed) for Bluetooth Low Energy communication
- 5.7-5.8 GHz (Unlicensed Industrial, Scientific & Medical, ISM) band for power transfer"
Re:Router can power your devices wirelessly from 15 feet away
by jrockway on Friday January 09, 2015 @08:26PM
(#8865467)
Same EIRP regulations and RF safety regulations for all ISM bands, as far as I can tell.
(900MHz has a slightly difference RF exposure calculation that you have to do compared to 1300MHz and up. But 2.4 and 5 are the same.)
If they aren't, they can still get 1W theoretically, which is actually useful: it can kind of charge your phone in 8 hours. Assuming 100% of the power is captured by the antenna, that is. (Note that I say theoretically: the real world is very bad for theoretical models.)
Also something to worry about: the FCC's maximum permissible radiation exposure. For 6 minute controlled application (people near the transmitter know it's on), you're allowed an energy density of 5mW per square centimeter. An iPhone 4 is about 55 cm^2, so that would mean a maximum of 275mW. That would charge the phone in 24 hours. (These are guidelines for amateur radio operators, not Part 15 devices; I don't know what the regs around Part 15 say about power density. The regs also cover far-field effects, not near-field effects, so perhaps they can get around these.)
Finally, if you want to play with beamforming and figure out how to get 100% of the power to a 55 cm^2 area, try: http://apenwarr.ca/beamlab/