Re:Underactuated Rotor for Simple Micro Air Vehicles
by Vendan on Tuesday December 16, 2014 @11:29AM
(#8757803)
that is a horrible article, considering the picture they are using is ripped off of a reprap blog on smoothing abs prints using acetone vapors. http://blog.reprap.org/2013/02/vapor-treating-abs-rp-parts.h.... (I'm actually a member of Fablocker, so I'd seen those squirrels before)
Re:Underactuated Rotor for Simple Micro Air Vehicles
by durkie on Wednesday December 17, 2014 @12:15AM
(#8761176)
well shit. we tried putting some big pla prints in the oven last night and they definitely just started warping and caving.
Re:Underactuated Rotor for Simple Micro Air Vehicles
by Vendan on Wednesday December 17, 2014 @12:46PM
(#8763280)
on that note though, from my experiments, acetone vapor bath does seem to strengthen abs prints some, cause it melts the surface together. Not terribly big effect, but it actually helps a lot for low infill parts and stuff.
as a side note, this looks like kind of a cool way to smooth pla prints, for which up till now there wasn't really a great option.