So, we can just about build Mauna Kea with bricks.
Also, this only works if, for any given slice, the weight of the legos above is evenly distributed over the legos below. Without stronger materials to transfer this weight, the legos in the center of the bottom of the tower will fail before those on the side of the bottom.
No. The total mass above a distance H from the top of the tower is
M(H) = \rho \int_0^H a(h) dh
where a(H) is the cross-sectional area of the tower a distance H from the top, and \rho is the density of the tower material. This total mass must obey
M(H) = a(H) * r / g
where r is the force per unit area that the material can support and g is the acceleration of gravity. Setting the right-hand sides of the two equations together and differentiating by H gives
r/(g \rho) (d/dH)a(h) = a(h)
which means
a(h) = exp(h (g \rho/r))
> And the weight doesn;t have to be exactly evenly distributed at the bottom, all that's necessary is that some of tghe weight of the upper cneter bricks is suppoorted by the lower outer bricks.
The distribution problem gets worse and worse as the taper continues, because more and more of the new area is further away form the center.
Of course, you are right, if they built a LEGO mountain, they might pull it off; but that wasn't what they was asking for.
The constraint of having a constant cross section is not part of the definition of a tower, I really don't understand why they make that assumption in the article. It was really an awkward read, thinking "just build from a larger base" at each paragraph.
If we look at Burj Khalifa or the Eiffel Tower, they certainly have large bases.
edit: actually the debate on the definition of tower vs mast vs tall building, habitable, free-standing, and the discussion pages on various articles (Tower, List of tallest towers, etc.) were a more interesting read than the article :-)
Or just use lighter 2x16 blocks at the top moving down to a mix of 2x4 and 2x2 at the bottom. Still wind is probably the largest issue.
I'm assuming you're spreading the weight, but lego bricks have quantised sizes, wouldn't that put a limit on the rate you can spread it?
>So, 375,000 bricks towering 3.5km (2.17 miles) high is what it would take to break a Lego brick.
>"That's taller than the highest mountain in Spain. It's significantly higher than Mount Olympus [tallest mountain in Greece], and it's the typical height at which people ski in the Alps," Ian Johnston says (though many skiers also ski at lower altitudes).
>"So if the Greek gods wanted to build a new temple on Mount Olympus, and Mount Olympus wasn't available, they could just - but no more - do it with Lego bricks. As long as they don't jump up and down too much."
Well, in theory you can go as high as you want, by tapering the tower towards the top. The 3.5 km limit is only valid for straight, constant cross-section structures.
Which mountains certainly are not.