News for hackers. Stuff that matters.
Re:Introducing Raspberry Pi B+ by usbreply on Monday July 14, 2014 @02:07PM (#8032282)
reread the usb spec. it will not ruin the USB port.
Re:Introducing Raspberry Pi B+ by makomk on Monday July 14, 2014 @07:11PM (#8033782)
Some really old computers have physical fuses on the USB ports that can - and will - blow if you draw too much power from them.
Re:Introducing Raspberry Pi B+ by CamperBob2 on Monday July 14, 2014 @09:10PM (#8034179)
Should probably upgrade, then, before spending more money on Raspberry Pis.
Re:Introducing Raspberry Pi B+ by ajross on Monday July 14, 2014 @02:42PM (#8032480)
I'm not aware of any spec requirements for overcurrent protection on the host ports (devices have strict power behavior per spec), though they may be there.

I am aware, however, of countless USB host designs that simply put a 5v regulator rail on the power line and could probably be induced to overheat by a misbehaving device.

Re:Introducing Raspberry Pi B+ by throwketchup on Monday July 14, 2014 @09:53PM (#8034325)
It's definitely in the USB 1.1 spec, (with some verbiage that excessive current draw on one port is not allowed to affect other ports) though they may have relaxed it later. I have several old Belkin hubs that will terminate (with prejudice) power to any port that draws over 550 mA, until you physically power-cycle the hub. This is annoying for obvious reasons, especially on 7-port hubs with beefy power supplies, so most hub manufacturers don't do that anymore.
Re:Introducing Raspberry Pi B+ by sitkack on Monday July 14, 2014 @03:40PM (#8032767)
What the pi should do is monitor the voltage level of port it is drawing from, if it draws it down, it should turn on a fault LED or disable onboard services (like ethernet and usb).