Re:‘Solar’ jet fuel made out of air
by zackmorris on Saturday May 03, 2014 @02:55PM
(#7691954)
Ya I think you're right, the float needs to be as thin as possible, otherwise most of it will be underwater and not affected when the surface rises. So a 1 MW float would have a volume of about 4 million m3, which is 2 km on a side if it's 1 m thick. It's probably better to just find large bays and install low head turbines. Kinda fun to do the math though!
Re:‘Solar’ jet fuel made out of air
by dredmorbius on Saturday May 03, 2014 @03:08PM
(#7691996)
It's not that the float needs to be thin. It's that the thickness doesn't matter in terms of power generation.
The minimal requirement is that the float, well, float. Other than that, more material is simply excess cost to consider.
The EPRI study I mention is based on, IIRC, turbines installed at the gate. Maximum capture would require building a barrier dam, which has been done at a few limited sites, though it would be impractical in SF due to ship traffic requirements.
Why?
Because the energy is derived from the tidal rise, not the amount of water you're displacing. The relevant volume is the area x the tidal displacement, which gives you the amount of water and how far it's been lifted (average: 1/2 the total displacement).
Or, if you prefer to have someone do the math for you, the City of San Francisco and EPRI did an analysis of how much total energy could be derived from tidal flows in and out of the San Francisco Bay, which I became interested in after an Internet crank suggested that the rise and fall of 30 typical ships could power all of San Francisco.
Not hardly.
http://oceanenergy.epri.com/attachments/streamenergy/reports...
The narrow passage under the Golden Gate Bridge, which connects the San Francisco bay to the Pacific Ocean is home to some of the most energetic currents in North America. In average 237MW of power is embodied in the tidal stream, of which about 35MW could be extracted without any negative impact on the environment. A plant of that scale could reach an electrical output of about 100MW at peak.
http://www.sfenvironment.org/article/hydro/tidal-energy
The study conservatively estimated that the Golden Gate site has 35.5 megawatts of total extractable average annual power, and that 15 to 17 average megawatts (MW) of this power could realistically be extracted by technologies currently in development. The cost of electricity generated, assuming incentives similar to those provided to other renewable resources, is estimated at six to nine cents per kilowatt-hour (kWh)—a cost competitive with current wind and natural gas generation, and about one-third the cost per megawatt of solar power.
As I recall, this works out to maybe 10% of the average power utilization of San Francisco proper, and a minuscule fraction of the energy used by the greater Bay Area. You'd do better to plaster the Bay with solar panels.
More: http://redd.it/1wefio
Tidal and wave energy are prodigious on a global scale, but they're simply too dispersed and too expensive to collect for present industrial-scale levels of energy use.