Re:Ask HN: Idea Sunday
by jtregunna on Sunday April 06, 2014 @05:01PM
(#7542929)
And where exactly would it drain to? Your toilet's output is plugged, thus causing the overflow, remember?
[ Parent
| on HN ]
I'd imagine it would be somewhere beyond where your toilet is typically clogged. That would handle most overflow situations.
A more practical approach might be a way to stop water from going into the bowl. E.g., you lift up on the handle to close the tank flap. Or maybe there's a stop button next to the flush button.
That would be almost as good as an overflow drain, but wouldn't require adding second sewer pipe.
Re:Ask HN: Idea Sunday
by maxerickson on Sunday April 06, 2014 @05:54PM
(#7543217)
A solid linkage between the handle and flap is available.
(The toilet in the room a little ways from where I'm sitting has one)
Re:Ask HN: Idea Sunday
by PavlovsCat on Sunday April 06, 2014 @10:09PM
(#7544263)
Re:Ask HN: Idea Sunday
by pritambaral on Monday April 07, 2014 @04:29AM
(#7545259)
Overflow completely overrides the effect of S-bend. There is a (pretty important) reason behind S-bends.
Simply add an additional S/U bend to the overflow. Less likely to get clogged as the overflow is hopefully rarely used.
Re:Ask HN: Idea Sunday
by PavlovsCat on Monday April 07, 2014 @02:58PM
(#7548537)
The overflow is only for water, right? Then a filter at the overflow entrance (or just the opening being narrow enough, two/three small holes maybe) could make positively sure the overflow bend cannot possibly get clogged.
Re:Ask HN: Idea Sunday
by petersouth on Sunday April 06, 2014 @07:47PM
(#7543775)
my bathtub is like 1" lower than the rim of my toilet