Re:A Printer That Can Print a 2,500 Square Foot House in 20 ...
by moocowduckquack on Monday October 28, 2013 @03:51PM
(#6629333)
They do show in the video the robot putting down steel beams for those lintels to be fair, so they have obviously planned for it.
Along the same lines I have been sketching designs for a robot to lay down 2-part foam, wire mesh and shotcrete, though I have been trying to work out if I can get it to climb its own wall, rather than needing a giant crane.
Re:A Printer That Can Print a 2,500 Square Foot House in 20 ...
by sitkack on Tuesday October 29, 2013 @12:35AM
(#6632053)
Depends on the build speed. It could "print in" holes into the wall and use a scissor action ... but I don't think that would work. You want the whole concrete/ferro cement to setup at once. An overhead cement pump and a much smaller more precise placement head/nozzle would probably be a better choice. Anything you can reuse from existing construction tech the cheaper.
My point is not that the problems are not addressable, they are, rather its that "3D Printing" and "Homes" isn't a good fit yet given what we know. This neither invalidates 3D printing as a pretty revolutionary way to manufacture, nor the notion that there might be better ways to build homes, just that this particular thought experiment is a pre-mature at best, and potentially forever impractical.