News for hackers. Stuff that matters.
Re:A 3D printed toothbrush for all your teeth by jotux on Tuesday October 01, 2013 @02:05PM (#6477937)
I've had basically the same idea as the the article, but for flossing, since I was a kid. You would mold your teeth and then cut slots in the mold between the teeth. You would then string floss through all of the slots and put the whole thing in your mouth. A single bit down would floss all of your teeth at once. A neat idea, but not that practical.
Re:A 3D printed toothbrush for all your teeth by klipt on Wednesday October 02, 2013 @05:05AM (#6481413)
But moving floss vertically in and out is bad flossing technique. You're supposed to curve the floss around the tooth:

http://www.oralb.com/topics/proper-flossing.aspx

> Contour floss around the side of the tooth.

Re:A 3D printed toothbrush for all your teeth by jotux on Wednesday October 02, 2013 @11:54AM (#6483183)
This is why it's not practical.
Re:A 3D printed toothbrush for all your teeth by gcb0 on Wednesday October 02, 2013 @01:51AM (#6480887)
Take my money!