Re:We taught robots to carve marble sculptures
by ewiesler on Wednesday November 18, 2026 @12:18PM
(#50549053)
We taught KUKA KR240 robots to carve carve marble sculptures end to end with autonomous toolpathing and simulation, starting with the Stanford bunny as a test case. Here’s how it goes from 3D model to finished sculpture using voxel representations and geodesic path planning.
[ Parent
| on HN ]
Re:We taught robots to carve marble sculptures
by moeffju on Thursday November 19, 2026 @07:43AM
(#50559368)
Cool work! Could you maybe say a few sentences about where/how specifically this improves on the current state of the art? I was under the impression that whole monasteries in Italy are running fleets of CNC robots to create marble sculptures - is your process easier to set up, does it go further, does the old process need human finishing etc.? Thank you!
Re:We taught robots to carve marble sculptures
by le-mark on Thursday November 19, 2026 @07:49AM
(#50559424)
> We taught
What does this mean exactly? Is the robot not being fed gcode?
Re:We taught robots to carve marble sculptures
by Joel_Mckay on Thursday November 19, 2026 @09:57AM
(#50560959)
Multi-access robotics is NP-hard, and only a closed-loop soft-real-time path correction is feasible. It is usually something pre-baked similar to gcode. =3
Re:We taught robots to carve marble sculptures
by GrinningFool on Thursday November 19, 2026 @07:55AM
(#50559500)
The words in the post look LLM generated. For some portion of us, that's offputting.
Aside from that, this stood out:
> our mission is to continue to work with artists and designers to decide on the final desired sculpture, and hand carvers to finalize the surface quality of many of our pieces.
This sounds good on the surface (hah) but it seems like it's only valid until the technology allows that work to be replaced too.