Re:The Raspberry Pi Education Manual
by StavrosK on Thursday January 03, 2013 @05:52AM
(#5001806)
I recently discovered you can use the pins on the Raspberry Pi to programmatically toggle switches! As a software guy, I find that magical. I ordered a cheap 8-relay board [1], and I'll hook some stuff up to it and turn my house devices on and off via the internet!
Re:The Raspberry Pi Education Manual
by Zuph on Thursday January 03, 2013 @07:52AM
(#5002101)
Not to burst your bubble, but Raspberry Pi IO pins operate at 3.3 volts, and the board you linked requires 5 volt logic inputs. It might still work, since there are no specs available for the transistor on the board, but don't count on it!
Re:The Raspberry Pi Education Manual
by StavrosK on Thursday January 03, 2013 @07:54AM
(#5002110)
The Raspberry Pi provides a 5V out pin at ~ 300 mA, so it should work, if the transistor works at 3.3V. Also, someone has tried it, and it worked. I just hope it's the same board.
Re:The Raspberry Pi Education Manual
by astine on Thursday January 03, 2013 @10:03AM
(#5002600)
FYI, It's ok to output at 3v3 volts to a 5v device if the device will still work, but don't read input from a 5v device or you might damage your Pi; the pins are wired directly to the Broadcom chip with no resistance.
Re:The Raspberry Pi Education Manual
by Maxious on Thursday January 03, 2013 @06:31AM
(#5001889)
See http://wiki.creativecommons.org/4.0/NonCommercial especially "NC Proposal No. 9: Create a new CC license, NC-EDU, that prohibits non-commercial uses, but allows educational uses" for further discussion of this issue.
[1] http://dx.com/p/8-channel-5v-relay-module-extension-board-fo...
PDF: http://downloads.raspberrypi.org/Raspberry_Pi_Education_Manu...
So not an Open Educational Resource.
"This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License."