News for hackers. Stuff that matters.
Re:TCXO Failure Analysis by garaetjjte on Tuesday March 10, 2026 @10:24AM (#47323714)
On the other hand I heard that one shouldn't trim leads after soldering as it might crack solder joints...
Re:TCXO Failure Analysis by codehero on Tuesday March 10, 2026 @11:06AM (#47324286)
Depends on the quality of the solder joint. Poor quality solder joints do not survive mechanical shock. If you are fighting a GND pin that sinks a lot of heat, using leadfree solder and you aren't that skilled...don't trim that lead flush with the PCB. Otherwise, if you are sure that the solder has wicked into the hole, trim away.

So if someone is telling you not to trim the lead...I'll let you draw your own conclusion.

Re:TCXO Failure Analysis by jnd-cz on Tuesday March 10, 2026 @10:54AM (#47324109)
This depends how close to the solder joint (or to board) you are trimming. If you're already cutting solder together with the component lead then it's too close and can affect the quality. I'm sure the NASA soldering manuals show this in great detail.