News for hackers. Stuff that matters.
Re:3D-Printed Mathematical Lampshades by dole on Wednesday January 28, 2026 @04:21PM (#46801704)
I was able to take the image of the star-shaped graph from OP, fed it to claude and used this for the prompt: "figure out a good formula or equation for this graph and use it to create the lampshade in openscad. use the graph as the bottom for a lampshade, and taper it all up to center point. leave a hole at the top big enough for a lightbulb fixture to pass through." It did a surprisingly good job of generating the OpenSCAD, STL, and preview renders in-browsers.

There are no comments on this comment yet.