https://en.wikipedia.org/wiki/Missile_guidance#Astro-inertia... ("the latter of which was adapted for the SR-71...")
(Actually the very first one, in that history, was an intercontinental cruise missile—a jet weapon that slightly predated (~1958) rockets powerful enough to cross oceans. ICBM's came a bit later. I'm pretty sure the first generation were pure-analog circuits, but I forgot where I read about that).
https://en.wikipedia.org/wiki/Standard-gauge_railway << This makes for fun reading if you're interested in that sort of thing.
Relevant passage
A popular legend that has circulated since at least 1937[8] traces the origin of the 1,435 mm (4 ft 8+1⁄2 in) gauge even further back than the coalfields of northern England, pointing to the evidence of rutted roads marked by chariot wheels dating from the Roman Empire.[a][9] Snopes categorised this legend as "false", but commented that it "is perhaps more fairly labeled as 'Partly true, but for trivial and unremarkable reasons.'"[10] The historical tendency to place the wheels of horse-drawn vehicles around 5 ft (1,524 mm) apart probably derives from the width needed to fit a carthorse in between the shafts.[10] Research, however, has been undertaken to support the hypothesis that "the origin of the standard gauge of the railway might result from an interval of wheel ruts of prehistoric ancient carriages".[11]Old school Open-CV was able to see tracks well from an onboard monocular camera, but calibration and scale was annoying. Track width is accurate enough that I was able to use it to input a bunch of head-end video to map the tracks.
It was mostly just a modified edge detect where the tracks approximately would be. Once finding the tracks, you could automatically calculate the camera's height, lateral location, and angle.
Since GPS is quite likely going to be unavailable at the time of use.
This Wikipedia entry isn't what I had in mind, but it describes an interesting analog mechanism,
- "For guidance systems based solely on star tracking, some sort of recording mechanism, typically a magnetic tape, was pre-recorded with a signal that represented the angle of the star over the period of a day. At launch, the tape was forwarded to the appropriate time.[2] During the flight, the signal on the tape was used to roughly position a telescope so it would point at the expected position of the star. At the telescope's focus was a photocell and some sort of signal-generator, typically a spinning disk known as a chopper. The chopper causes the image of the star to repeatedly appear and disappear on the photocell, producing a signal that was then smoothed to produce an alternating current output. The phase of that signal was compared to the one on the tape to produce a guidance signal.[2]"
* https://theaviationgeekclub.com/the-sr-71-blackbird-astro-na...
* https://www.twz.com/17207/sr-71s-r2-d2-could-be-the-key-to-w...
* https://en.wikipedia.org/wiki/Missile_guidance#Astro-inertia...
Did the planes have to fly above clouds?
Info here: https://www.sr-71.org/blackbird/manual/4/4-3.php
It wasn't exactly a simple instrument to use, and it relied on a ton of planned course information. You could also do a cold midair start after a power outage, but preflight would be much more preferable!
Some modern microwave telescopes like BICEP3 have an additional optical telescope for star pointing that are daylight-usable, but in summer you need to use a big baffle tube. The images are taken with a high sensitivity CCD camera and you can pick out brighter target stars surprisingly well in the images.
i know gaia data for instance is available for free but if one used just a homemade telescope could any useful celestial data be acquired?
BICEP, however, is located at the South Pole on a moving ice sheet, requiring frequent updates to its pointing model, and has six months of continuous daylight, so daytime star pointing observations are required. This requires a different technique. Instead of looking at asterisms with multiple stars, the optical pointing telescope is pointed at a single star using an initial pointing model, the telescope pointing is adjusted until the star is centered, and the offset is recorded. This measurement process is repeated for the few dozen brightest stars, which acquires the data needed for refining the pointing model.
One of the more "useful" backyard astronomy tasks that is achievable for a dedicated amateur is variable star observation (eg AAVSO), because many stars don't need huge telescopes to observe and it's very expensive for a big observatory to stare at a single patch of sky for weeks. Nowadays we have instruments like LSST which is basically designed for this sort of surveying, but public data are still useful. And you do need to know exactly where you're pointing, so either you do this manually by pointing at a bunch of target stars, or you can use a guide scope that solves the field for you.
Definitely! I wasn't expecting to see a mention of BICEP while reading HN from Pole, particularly not on something as arcane as its star camera.
https://www.youtube.com/watch?v=GkEjLqu-JH0&list=PL-_93BVApb...
Recommended.
It also immediately occured to me how much easier this should be on a copter, since you don't need a gimbal'd platform :)
He's got a bunch of other vintage electronics stuff that's from the early space program as well, interesting stuff to see the insides of that gear.
The SR-71 and U2 planes had automated celestial navigation systems b/c GPS wasn't around when they came out.
There a story in the book about Lockheed Martin's Skunk Works where they mention turning on the system while one of the planes was in the hangar and it locked on to a hole in the roof (sun was shining through the hole and system thought it was a start).