Notifications should be actionable.
“The Sonos speaker is too loud” is a sort-of helpful message. I can infer the action.
Better is “the Sonos speaker is too loud, you should turn it down”.
Even better is “the Sonos speaker is too loud, click here to go to the volume settings”.
And better yet is “the Sonos speaker is too loud, should I turn it down?”
But best is the program just doing it and shutting up about it.
And best of all is just setting the volume limit on the speaker: https://support.sonos.com/en-us/article/setting-a-volume-lim....
A program that turns the volume down once a speaker gets too loud is, functionally, the same thing? Assuming the feedback is instant, i.e. it instantly decreases the volume.
If there's a delay, however, I can see how a notification might be helpful, if only to alert people, "Hey, this isn't just magically getting quieter. There's a program we've set up that does it."
What would be cool is an ambient noise sensor that can turn down the music if a room gets too loud, say from people talking over the music.
I have faced my share of micromanagers but nobody has ever told me how to set my notifications.
a world of liability is escaped by avoiding that feature add. This is similar to why self-closing doors/trunks/hatches took so long to catch on. It wasn't a technology problem, Cadillac and Rolls Royce showed this stuff in the 60s -- it was a liability gamble.
I've been living here for months and I still forget to close it half the time. But, at least it has a "helpful" feature that beeps at me (very quietly) if it's left open.
It's fine if it tries but only weakly, and fails sometimes because of that.
One fridge failing every time is still just "sometimes" for the design.
Failing to chop off a babies head is an intentional part of the design, and it's still auto-close even when it fails to close because of an obstruction or improper installation or manufacturing defect or even because of a bad design that would never work well but was intended to.
There's no way any fridge is actually designed to stop before closing. That will be some assembly or desgn flaw like the seal rubs or something.
I had to hack my mother in laws fridge to prevent the door seals from interfering and preventing the doors from closing all the way. It worked fine when it was new, but after a short while the shitty design of the door to door seals, the seals hit and rub on each other and and after a while the seals started to pull out to where they then interfered. The door was still designed to close itself, and tried to, just another part of the design sabotaged that intention.
It's such a weak force normally that it's easy interfere with. A hinge installed slightly off will look fine and work fine, but the seal on the hinge side maybe rubs just a bit, and that's enough to spoil it. Or a nick in a teflon washer acting as a bearing, producing a detent resting spot. Could be anything but there is no way it's in the drawings and designed to do that.
Huh? There are no refrigerators that don't have that feature.
The ideal refrigerator should self close from any angle of open-ness. This is definitely not the case in general today.
Yes, of course; what do you think the alternative was? There are no refrigerators that don't have that feature.
In that spirit, it seems better to have a speaker that can't be set higher than the "approved" maximum. If this thing is measuring actual sound level rather than set volume, a slow release limiter, either in software or hardware would just make it automatically correct without the whole notification cycle thing.