So a 15W LED light would only need 3W of cooling? It feels even more ridiculous when we put the numbers like this... There is no excuse for LED lights to not have adequate cooling or for them to fail because of overheating...
> This means that about 80 percent of the electrical energy is converted to light, while 20 percent is lost and converted into other forms of energy such as heat.
That same logic might still apply for modern light solutions like LEDs. I have a more expensive LED bar which is build on top of aluminium to disperse the heat.
Did you have heard about the Dubai Lamp? It’s basically a very efficient longlife LED which they only sell in UAE.
They are damn impressive, but not "forever".
One small exception may be microntollers that use PWM to emit a signal through an antenna, or to drive a motor. I think in that case some of the energy becomes radio waves (which may never be absorbed entirely so they may not become heat) or motion in the motor.
In the context of CPUs, yes, the heat produced is equal to the input power. However this is not at all true for light bulbs, for motors, for battery chargers, etc. A light bulb in particular transforms some of the electrical energy into heat, but some of it into emitted light.
Even in incandescent bulbs, some the electricity gets turned into heat, raising the temperature of the filament, but past some point, the temperature no longer increases and all the extra energy gets converted into light. That is, if you were to submerge an incandescent light bulb in a large quantity of water and leave it on for 10 minutes, you'd get cooler water than if you submerged just the filament (ignoring the possible shortcircuits): if the temperature of the filament is kept below the point where it emits light, than all the electrocity goes into heat; but if it starts emitting light, then some of the energy escapes and doesn't heat the water.