News for hackers. Stuff that matters.
Re:Why do electronic components have such odd values? (2021) by retrac on Tuesday June 04, 2024 @02:08PM (#40577300)
Resistors with worse tolerances may be made out of cheaper, less refined wire, which will vary resistance more by temperature. The tolerance and resistance is good over a temperature range. For more reading looking up "constantan".
Re:Why do electronic components have such odd values? (2021) by RetroTechie on Tuesday June 04, 2024 @02:26PM (#40577473)
Most resistors don't use wire, but some film of carbon (cheaper, usually the E12 / 5% tolerance parts) or metal (E24, or 1% and tighter tolerances) onto a non-conducting body. Wires mean winding into a coil, which means increased inductance.

I suspect in most cases the tolerances are a direct result from the fabrication process. That is: process X, within such & such parameters, produces parts with Y tolerance. But there could be some trimming involved (like a laser burning off material until component has correct value). Or the parts are measured & then binned / marked accordingly.

Actual wire is used for power resistors, like rated for 5W+ dissipation. Inductance rarely matters for their applications.

Re:Why do electronic components have such odd values? (2021) by Gibbon1 on Tuesday June 04, 2024 @04:28PM (#40578616)
Accuracy depends on the technology used. Carbon comp tends have less accuracy then carbon film. And it's not true that higher accuracy is always better.

Some accurate resisters are essentially wound coils and have high inductance and will also induce and pick up magnetic interference. Stuff like that matters often a lot.

Re:Why do electronic components have such odd values? (2021) by projektfu on Tuesday June 04, 2024 @02:27PM (#40577484)
Thanks, always good to remember that the tolerance of a resistor is not just a manufacturing number but also defined over the specified temperature range.