News for hackers. Stuff that matters.
Re:Bento3D by sitzkrieg on Tuesday May 21, 2024 @01:29AM (#40424506)
there is a large selection of food safe filaments like TPU
Re:Bento3D by ecjhdnc2025 on Tuesday May 21, 2024 @03:55AM (#40425316)
This is a well-worn topic, but FDM has many potential issues that make food-safe printing significantly challenging.

It is alas not enough to use a food-safe filament; you need a food-safe extruder drive and nozzle, and almost certainly will need print post-processing to make the printed item physically food-safe.

The issue with a lunchbox is acute because it has potential contact with individual items of food for hours at a time, on a regular basis. It's the perfect setup for bacterial growth in the layer lines -- close to the worst-case scenario.

There would be ways to mitigate that (liners etc.) but arguably even a food-safe filament would need considerable vapour smoothing or coating.

Hard TPUs up at the Shore 75D range would be tough enough for the job but they would scuff up while cleaning, and are resistant to coatings etc.

(Side note being that 75D TPU is quite capricious to print.)

Re:Bento3D by varispeed on Tuesday May 21, 2024 @07:44AM (#40427055)
Have you printed with TPU? It's very porous.
Re:Bento3D by Filligree on Tuesday May 21, 2024 @09:25AM (#40428207)
Everything is porous when printed.
Re:Bento3D by sitzkrieg on Wednesday May 22, 2024 @12:10AM (#40437248)
blowtorch or acetone bath etc can make some nice pieces

i mostly stick to petg for everyday stuff tho