And, you don't need to add insulation, but we did (to the crawlspace), costing about $2.5k
And, it's been running for about 3 months, and saved about ~$175/month in heating. wow. It'll pay for itself in about 7-8 years.
How are heat pumps typically installed? Are they integrated into the radiator/hot water system? Or is some sort of forced air system setup installed?
I'd assume a mini split setup wouldn't be too uncommon. (Probably the cheapest route for most homes in the UK).
In the US the vast majority of homes and apartments are setup with forced air heating and cooling which really simplifies transition. I'd assume the UKs setup where everyone uses heated water to heat homes would make transition more expensive and costly.
Some new builds have mechanical ventilation heat recovery, which is a ventilation system with a heat exchanger. But I don't hear much about air to air heat pumps.
It's very possible I'm wrong in my perceptions here!
I'd assume that would cause a lot of issues if it is as chilled water would generate condensation (and the UK is nice and humid 24/7)
Europe has more hydronic/radiator mono-block heat pumps, with no refrigerant work needed in the field, which makes them easier to retrofit, assuming all the other plumbing is in place. Refrigerant work requires more training due to the high pressure and the potential for the high-GWP refrigerant.
I think this somewhat overblows the complexity of a heat pump.
They are simply Air conditioners that can be ran in reverse. One valve is the difference between a heat pump and AC. Why they are so expensive is really just price gouging because they aren't as common.
If you are in a home with forced air AC then installing a heatpump system couldn't be simpler and should be something you consider when updating your AC system. It's really just a matter of updating the compressor and maybe adding some smarts to avoid condensation. In fact, it's shocking to me that AC -> heatpump conversion kits haven't hit the market.
> So i'm slightly mystified that we basically don't hear anything about fitting drainwater heat recovery [1], in which the lukewarm drain water from your shower is used to pre-warm the incoming cold water. It's extremely simple, pretty cheap, simple to fit, and can recover ~50% of the waste heat, of something which is tens of percent of the energy consumption of a household.
Really interesting idea, but I assume you have to rip up the shower to accomplish this right? Also, I'm guessing clogged wastewater piping might be an issue right? That said, that'd be easily overcome by just running the lines side by side with maybe a simple copper connector for heat exchange.