News for hackers. Stuff that matters.
Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by foobarian on Friday April 05, 2024 @09:21PM (#39949165)
If I'm understanding this correctly, there won't be a way to print hollow parts, right?
Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by twelfthnight on Friday April 05, 2024 @09:29PM (#39949207)
Not directly like FDM, but my understanding is you can design the part with "escape holes", so it's possible in certain circumstances.
Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by FeistySkink on Friday April 05, 2024 @09:29PM (#39949209)
Why not? Or do you mean infill?
Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by Opossum on Friday April 05, 2024 @09:28PM (#39949206)
No. The sintering happens layer by layer. So you can print hollow parts.
Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by javawizard on Friday April 05, 2024 @09:38PM (#39949257)
You can print them, but the "hollow" chamber you print will be full of powder with no way to remove said powder. That's a well-established limitation of both SLS and SLA printing.

The classic way of getting around that is to leave a small hole in the chamber that's open to the outside - then you drain the powder out of that hole and, if needed, plug it up after you're done.

Re:Micronics Announces Desktop SLS 3D Printer, Starting at $... by greesil on Friday April 05, 2024 @09:33PM (#39949231)
I think the parent comment was concerned about having a closed chamber full of powder when the print is done