News for hackers. Stuff that matters.
Re:Low Cost Robot Arm by regularfry on Tuesday April 02, 2024 @04:42AM (#39903560)
There have been a few around, but the limiting factor (as you can see from the BOM in the link) is the cost of the actuators. They get expensive fast.
Re:Low Cost Robot Arm by hackable_sand on Tuesday April 02, 2024 @08:15AM (#39904860)
I was looking at electroactive polymers (EAPs) and I could not find a single company with consumer pricing...

I wish there was more visibility here without requiring a PhD.

Re:Low Cost Robot Arm by FeepingCreature on Tuesday April 02, 2024 @08:46AM (#39905100)
If they don't have to move fast, could you DIY an actuator with a stepper and a threaded shaft? Steppers are pretty cheap thanks to 3D printers.
Re:Low Cost Robot Arm by RobotToaster on Tuesday April 02, 2024 @09:06AM (#39905307)
There are arms using steppers and 3d printed epicyclic or cycloidal drives.
Re:Low Cost Robot Arm by FrojoS on Tuesday April 02, 2024 @09:31AM (#39905551)
For a useful robot arm, you need high forces/torques. Usually, this is achieved by high ratio [1] gearboxes between the motor and the joint. Those are expensive, and inefficient and make estimating the output force via the motor current almost impossible.

[1] In the order of 1:100, see e.g. https://www.harmonicdrive.net/

Re:Low Cost Robot Arm by FrojoS on Tuesday April 02, 2024 @09:27AM (#39905516)
Sensors too. E.g. force sensors are important for dexterous manipulation and safety. But they are all expensive, bulky, imprecise, or require constant recalibration, or all of the former. Our robotics Prof used to quote his industry peers: "The best sensor is no sensor."
Re:Low Cost Robot Arm by regularfry on Thursday April 04, 2024 @10:00AM (#39930505)
That's presumably one reason why everyone's so keen on doing all the force sensing from the motor current.
Re:Low Cost Robot Arm by zingelshuher on Thursday April 04, 2024 @08:41PM (#39937546)
Have to disagree with this. The major limiting factor is the software and lack of applications. If there was a killer application it would be much easier to sell. Then the numbers would drive the prices down.