News for hackers. Stuff that matters.
Re:Ethernet Is Still Going Strong After 50 Years by js2 on Friday November 17, 2023 @11:48AM (#38306105)
> That would be before CAT5e cable so if they had went with ethernet cable instead of coax you'd be looking at 100 Mb/s. If it was built before 1995 you'd be looking at CAT4 and under 20 Mb/s.

I've been dealing with twisted pair cable since the mid-90s and I've never seen Cat 4 cable anywhere, commercial or residential.

Cat 5/5e both support GigE. The primary difference between FE and GE with respect to cabling is that GE uses all 4 pairs where FE used only 2 pairs. The difference between 5 and 5e cable is pretty negligible, and the GigE standard only requires Cat 5, not 5e

With respect to Cat 4, you're confusing the signal bandwidth and data rate. Cat 4 supports up to 20 Mhz signal bandwidth. It can be utilized by either 10BASE-T (10 Mbit/s) or 100BASE-T4 (100 Mbit/s).

If there's twisted pair data cabling in the home at all, it's probably suitable for GigE. Otherwise it's likely RJ11 phone cabling that's not typically going to be in a home run topology.

That said, the standards are pretty forgiving over shorter distances. Here's someone claiming they got GigE speeds over Cat 3 cabling in an older home:

https://superuser.com/a/1281656

Re:Ethernet Is Still Going Strong After 50 Years by xen2xen1 on Friday November 17, 2023 @01:48PM (#38308090)
I thought gigabit required all four pairs, or am I missing part of what you said?
Re:Ethernet Is Still Going Strong After 50 Years by anamexis on Friday November 17, 2023 @03:22PM (#38309492)
They said exactly that.
Re:Ethernet Is Still Going Strong After 50 Years by kvmet on Friday November 17, 2023 @05:26PM (#38311362)
For typical Ethernet sure. Although there are newer standards that can use a single pair (1000Base-T1). They are very range-limited though and not what you would normally install in your house.

https://en.wikipedia.org/wiki/Gigabit_Ethernet#1000BASE-T1