I mostly just installed insanely loud tornado fans myself, which were in style at the time. This was before building a quiet PC was on anyone's radar it seemed.
This combined with my roughly 4 month itch to rearrange my office made it seem like much more of a pain in the ass than it was worth to ever actually do.
Plus, in the winter, you get "free" heating by running the machine completely indoors. Not actually free of course, but free as a side-effect of using the machine for other tasks. Had a friend who tried splitting his electrical service off into a cheaper heat-rate branch to run his bitcoin mining rigs and claimed they were the same as a space heater. I don't think the power company bought it.
Still, IMO a better solution is fixing the hardware. Many years ago, I had similar symptoms with an old thick HP laptop. I think I have paid something like $30 for the new fan assembly, it’s a large part which includes a fan, radiator and couple of heat pipes. The assembly connects to the motherboard with a small plug, no soldering was required. It only took half an hour (and a blob of thermal paste) to replace the part.
(Advice, prevent the fan from spinning while doing vacuum)
"Pro tip:" Do not direct the output of a strong air stream (e.g. the kind used for automotive work) at the fan as it can de-blade the fan.
Disconnect the fan cable from the socket so that the motor doesn't send pulses of energy back into your laptop. It probably won't harm it, but better safe than sorry.
https://forum.arduino.cc/t/is-a-flyback-diode-built-into-lap...
"You will find those fans are brushless DC fans, they are controlled by an inbuilt driver circuit and as such do not need a flyback diode."
What makes you think they're an authority?
Brushless motor still have fly back voltage that has to be clamped. You may not need to install a diode in the fan, but I can guarantee you that this "inbuilt driver circuit" has such a diode.
And if you read the linked thread a bit more you'd see where they test it and it does produce -100V at shutdown. If there wasn't a flyback diodes it'd be burning out ic's left and right
Its on you to provide evidence of your claim, not on me to disprove your unfounded claim.
In fact, for bearings which need grease, WD-40 can remove the very thing that is keeping the bearings from wearing out!
If the fan is very old and no longer works properly, it just needs to be replaced.
Sometimes it is really complicated replacing them with a danger of damaging stuff, if you have no routine. Then using something to spray is easier to fix it for some time. It helped in my cases, even though I will definitely try something else next time ..
An example of something better to use is 3-In-One Multipurpose or Motor Oil.
Another FYI is that oils break down grease, which is found in bearings (WD-40 aggressively so), so it’s not generally desirable to apply oil to bearings, unless it’s already having issues and you just need some additional life out of it.
Or, were you fully clothed and this was in Florida or something?
(I half joke, but when it warms up to 40 F again in the Spring, in Minnesota we break out the t-shirts, if not shorts.)
Each time I would try the system would overheat and then crash. The existing (windows) system still appeared to work fine with light loads so I was pretty sure I just needed to get past the install and decided to try one more time.
It was winter at the time, I can't remember if it had snowed recently, but I think it was probably close to 40 degrees F outside. So I hooked up a wired keyboard and mouse, and then plopped the laptop outside on the deck and closed the door with only the keyboard and mouse inside. There was a window which I could see the screen through and start the install.
Sure enough with the natural winter cooling the install completed and I was able to use the laptop for a few more years.