http://www.teslamotors.com/goelectric/charging
Using 120V @ 15A, you get a charge rate of +5 miles (of range) per hour. Obviously not the optimal solution, but not a net negative either. Adding a 100 foot extension cord isn't going to diminish the available current enough to result in a net negative, so either the owner had additional electrical issues, or simply failed to plug it in and is making up excuses.
Its possible that the Tesla simply won't charge at all if the current or voltage on the line becomes too low. In this case, it would be "plugged in" but not charging.
Edit: Lets figure it out: Range=244mi. Battery capacity=58kWh. So: 5 miles takes 1.086kWh. 10% is lost in chemical conversion so we really need 1.207kWh for those miles. We pull at a rate of 1.8kWh/h from the plug. So 600 watts or so is lost elsewhere. We know the "always on" battery cooling system alone takes around 150 watts. Its not that far fetched.
Edit: I deleted my comment below where I calculated the cost of keeping the car on standby because I don't think I made clear enough (and didn't want to type it all twice) the difference between the actual discharge rate of the battery and the amount of power required at the charger to stop it. It just seems to take a lot of power at the charge port before any gets to the battery. The battery seems to discharge at an average rate of just 30 watts, but it seems to take a much, much greater amount of power input to prevent this and failing to provide this power has dire consequences. Why?
Clearly there is about 20 times that much power available at the end of a 100 foot extension cord in a standard household outlet.
Failure modes available:
• Was not actually plugged in.
• Was unplugged then plugged back in much later, possibly unbeknownst to owner. (Someone in my household unplugs my DVR to use an outlet. Grr.)
• Was on a switched outlet. (I once bought a new drill over that. Who knew one of the duplex outlets was switched and the other not? But the new drill wasn't $40k.)
• The Tesla charger could have a cutoff where it stops charging if unable to pull X amps where X is somewhere between 7 and 15. This could be either intentional or unintentional. Brown out protection circuitry, if needed by the design, could do this. They also might fear they are setting your house on fire by dropping 800+ watts somewhere in a wall and shut off.
• Broken charger.
• Broken extension cord.
Which means you have a point. If the owner in question plugged the Tesla supplied 120v cord in to an additional 100-foot, 16 gauge cord, they might have a net loss situation on their hands.
This is probably necessary to achieve UL rating.
Additionally they quote it's happened 5 times... by an un-named service manager.
It looks like they switched from ignore/mock to attack. He's getting somewhere.
First they ignore you, then they laugh at you, then they fight you, then you win. --Gandhi
Not necessarily. This might help, but the battery will also have self-discharge, meaning that it can lose charge without being connected to any load at all. If you get the charge down low enough, and then wait long enough, then even a full disconnect from the system won't help.
"The Tesla manager called me to warn that my car was in trouble" is a much better customer experience than "my Tesla broke down, and cost $40k to fix".
Cars used to have the same problems with oil changes. This got better, as customers were educated (at the cost of a lot of cooked engines), and cars were able to warn their owners, and run for longer without oil.
Creepy? I'm more worried about the app-of-the-day sucking down my iPhone contacts. THAT I find to be more personal than my vehicle location.
In both cases though it's not the action so much as it is the fact that you weren't able to opt out of it, or in many cases you aren't even aware of the possibility of it happening.
It's the same violation, and in both cases it's equally creepy. Apple got called out and did something about it. What will Tesla do?
I don't know anybody in their right mind who would say no to that.
Small portable gadgets using LiPoly batteries (which I assume the Tesla is using) can be left for months or years without charging, and then nursed back to life. If sufficient charge is left in them, and the circuitry is smart enough to recognise that the battery's about to die, the time before complete discharge could be extended to a much larger period of time.
The solution could even be a one-time use fuse, isolating the battery completely. Given the option, I think most owners would rather have to replace a fuse than a $40k battery.
Jermy Clarkson must be pissing himself laughing over this
This all would seem to make sense to install though, it's far better to have a pack that needs a reset in the shop then a brick, esp. as the battery pack in the model S will make up nearly all of the resale value of the vehicle.
That wouldn't fix the Li-ion self-discharge problem completely, but it could provide as much as a few months' worth of margin.
In any case it's batshit insane to leave early adopters stuck with a $40,000 bill for your lack of engineering foresight. That was the real surprise in the article.
Even my iPhone can turn turtle to protect its battery when it gets too low.
Also how much power does it take to keep the damn thing plugged in? The article indicates that a 100 foot extension cord isn't enough just to break even and the car discharges even when plugged in. A 100 foot cord of cheap 16 gauge wire can still supply almost 900 watts before the voltage drops below 100v. So it uses a kilowatt just to stand-by without even charging? That's one hell of a power vampire.
I think maybe they should spend a bit more time on the fundamentals and a bit less time on fancy bird-wing doors if they want to have a real product. The real car of the future is just a big dumb tray full of indestructible nickle-iron batteries and 4 wheel-hub motors bolted to the corners.