Re:Automating the capture of airplane pictures with Raspberr...
by tpmx on Thursday May 11, 2023 @12:06PM
(#35904183)
I didn't think about the heat. Yeah, a DSLR with a decent lens is quite heavy. And expensive, so it needs to be protected.
It's a tricky problem to do on the cheap.
I don't think I'm prepared to spend $3K, my idea was rather to spend some fun time on HW work as a diversion from the regular paid SW work - and to put some use to that expensive camera gear I'm not really using.
Thanks for your lessons learned; they have been helpful!
Re:Automating the capture of airplane pictures with Raspberr...
by dekhn on Thursday May 11, 2023 @12:22PM
(#35904438)
Do you have a 3d printer? Spend some time cloning this:
https://www.bhphotovideo.com/c/product/689699-REG/Giga_Pan_E...
That's what I did. This time around, I'd just buy that.
When I built my own I hit a number of challenges: the 3d printed plastic parts melted in the sun (switched from PLA to PETG, printed in pure white). DSLRs with telephotos are heavy so I ended up using gearing. I should have put more time into balancing the camera to reduce the motor demands. I don't think a DSLR is ideal- I'd much rather use a small, cheap industrial camera, but I've never found the equivalent of an affordable 300mm telephoto that is C-mount and goes on industrial camera. I used stepper motors, not BLDC, without feedback (other than a zero-position limit switch) and a simple realtime algorithm for pointing; it worked, but wasn't really good enough to make the sunspot timelapses I wanted.
I think for this it makes more sense to buy a quality telescope motorized mount, a nice refractor telescope, and then put a DSLR at prime focus. It'd be about $3K but would save a lot of time compared to DIY.