Re:Ever wonder why plumbers are paid so much? Peek into the ...
by mannykannot on Sunday November 27, 2022 @11:00AM
(#33763799)
What do you think of the advice that it is acceptable to use a tapered male thread in a straight female one? My guess is that if you do that, you have at best one turn of the thread helix holding it together and providing a seal (and perhaps you would be trusting in nothing more than the tape jammed between the threads if you used ten turns of it!)
[ Parent
| on HN ]
Re:Ever wonder why plumbers are paid so much? Peek into the ...
by johnwalkr on Sunday November 27, 2022 @03:24PM
(#33766502)
I don’t think it’s acceptable. Maybe works in pinch to get through a weekend but I would always replace it with a proper fitting. Plus if you damage the female threads or o-ring seat, you’ve made a much worse problem for yourself.
Re:Ever wonder why plumbers are paid so much? Peek into the ...
by ethbr0 on Sunday November 27, 2022 @06:37PM
(#33768147)
It's probably a commentary on the idea that the tapered male diameter is its max diameter(?), versus straight is throughout.
Consequently, a tapered male will fully screw into a straight female, albeit with gaps between the threads at the deep end of the socket.
Whereas a straight male will at most only screw the first few threads into a tapered female, leaving most of the male hanging out.
Re:Ever wonder why plumbers are paid so much? Peek into the ...
by lazide on Sunday November 27, 2022 @08:54PM
(#33768997)
It’s asking to rip the threads out of the fitting (and have done so when trying). One way you’ll get some seal first, the other you won’t.
Re:Ever wonder why plumbers are paid so much? Peek into the ...
by johnwalkr on Monday November 28, 2022 @04:14AM
(#33771352)
Tapered pipe threads are actually
much larger than you’d expect given the nominal diameter. 1/4 inch tapered pipe threads have a maximum outer diameter of more than 1/2 inch and 18 threads per inch. They will sort of work with a 1/4 inch straight thread but not by fully screwing in.