v2 at least had 4 modes: user mode, supervisor, IRQ and FIQ. They were encoded in the low 2 bits of r15 (which weren't otherwise needed, since the PC was always word-aligned).
The original Archimedes was intended to run a "preemptively multi tasking, multi-threaded, multi-user, written in Acorn-extended Modula2+" system called ARX. But when that wasn't ready in time, they ended up just porting the 8-bit BBC Micro MOS to the new 32-bit machines!
This is a great read about it all:
http://www.rougol.jellybaby.net/meetings/2012/PaulFellows/in...
> Now, the aforementioned, Arthur Norman, who had written the LISP interpreter for the BBC Micro, and was in and out of Acorn the whole time, had come up with a design for a machine with 3 instructions called the SKI machine. Whose instructions were called 'S', 'K' and 'I' and it ran LISP in hardware and he built one of these things, it never worked, it was so big and covered in wire-wrap it was always broken. The idea was to prove that you really didn't need very many instructions for a general purpose machine.
By this point Acorn had already released two generations of its UNIX workstation line running its 4.3BSD + X11 based RISC iX, the ARM2 A440/1 based R140 and ARM3 A540 based R260.
It did have virtual memory though its large for the time 32k page size was awkward. It only supported DMA for video so the CPU needed to manually copy data from the hard drive controller.
It is somewhat fun to imagine an alternate world where Apple jumped to ARM instead of PowerPC, but they had other goals at the time. (Likely the whole 68k emulation story would have been very tricky with ARM at the time, tho)
[1] https://www.youtube.com/watch?v=_6sh097Dk5k, "A History of The ARM Microprocessor"
Plus Apple now has the cash and design team to design a very high performance implementation. It's not had that at the time of the last two transitions.
The StrongARM IP ended up with Intel as XScale when they bought out DEC's semiconductor manufacturing operations as part of a legal settlement. But the lead of Digital's design center that built StrongARM went on to form PA Semi, who Apple bought in 2008. The first Apple-designed ARM chip was released a couple of years later with the iPhone 4 in 2010.
Also, Apple didn’t just fund and design a good implementation, ARMv8 was created for the project in the first place.
Also
https://twitter.com/TheKanter/status/1346480394057650177?s=2...
Also it's interesting that when the first Armv8 CPU came out there wasn't any mention by Apple of it being made for them - which is odd given how much weight they give to Apple's input and control elsewhere.
Except the original IBM 801 RISC was built - with c20 people - explicitly to compete with VAX. The next set of RISC machines likewise had small teams and high performance.
The whole 32016 approach was just less effective both from design and performance perspective.
But it came out around the same time period as the 68000 -- a very similar chip -- which is no less complicated. And that processor was enormously successful. (From what I've seen of the NS32k it was basically... A lot like 68k but little endian and witha smaller register set that wasn't split into address vs data registers)
My point is that 'engineering complexity' can be measured in all sorts of ways. It took 15 years after that period for RISC to truly prove its way, and even then it's been heavily modified from the original "recipe."
What makes ARM interesting to me is that it applied RISC principles in a way that worked well for lower cost computers.
Incidentally you might enjoy this from 1986. They were having the same debates back then as we are now!
The 320xx, like the 68k, was targeting the nascent Unix workstation market and minicomputer-competition. It was explicitly VAX like -- except simplified (apparently 32xx was quite a clean and consistent architecture). As others have pointed out, it supported everything needed for virtual memory (better than the 68k, actually)
I am not sure ARMv1 (and v2) even had supervisor vs user mode, etc.? (It may have, Google isn't helping me here)
Eventually the 68k ended up in consumer microcomputers (Amiga, Atari ST, etc.) but it started out in that same market. People who wanted to take a bite out of VAX's lunch (which was big money back then.)
The ARM was built by a microcomputer company, for the next generation of their microcomputers. And then for the nest 30 years it was used in various forms for embedded and portable / low-power systems (apart from the ill-fated Archimedes line which was kind of Atari/Amiga/Mac level competition) . It's only in the last few years that we're seeing it in server and workstation class systems.
Note that Apple was an investor and user in ARM from the very earliest days but only in the last couple of years has seen it wise to put it into that class of machine. They went from 68k to PowerPC, and from PowerPC to Intel without choosing ARM for the job, even though they were already a huge ARM customer and had already ported their OS.
Different market, different kind of project.