A 30-ton 5-axle HGV would be 6 tons per axle, a BMW 7-Series would be 1 ton per axle, and a heavy cyclist on a heavy bicycle would work out to around 0.05 tons per axle, so while a car might cause ~1/1000th of the wear of a heavy truck, a bicycle would cause less than 1/100000th of the wear that is caused by a car, and that's before you consider the wear that's caused according to the speed that a vehicle is traveling (it is roughly linear). So while it might conceivably be possible to tax motorists according to the level of damage that they cause to roads (with trucks paying far more than they do now, and with revenues not exceeding the costs of collection), it certainly wouldn't be possible to tax cyclists.
It might cost a semi truck $50k a year, but this also points in the direction of not tracking specific usage even for trucks: Just check the odometer during the annual inspection and then distribute the highway funds to states proportionate to estimated use.
Toll collection is stupid inefficient and privacy invasive.
And if people wanted, the President of the National Cycling Federation could present the Secretary of Transportation with a $5 bill in an annual ceremony.
So let say the truck has a $5000 tax to pay for yearly wear and tear on roads, but they also get a $5000 tax cut to reduce costs in the transportation sector. That will leave cars to still pay their road tax, even if in comparison they would be a tiny portion of the total road tax.
The reality is probably that it's not that well coupled to any cause, and really it's just a way to farm money from the majority of the country, who need to use motor transport to live their lives. The advertised political reason will change depending on the concerns of the populace at the time.
Isn't car wear and tear minimal to HGV wear and tear?
Though cars still put out a fair bit more pollution from tire wear than bicycles do.
That is the case, which came as a surprise to me.
For things like the road bed, where the force from the surface is going to be spread out more, I'd expect the car to do more damage because total weight would be all that mattered.
But for damage at or near the road surface I'd have expected bikes to do more.
My reasoning was simple: although cars weigh a lot more they are spreading that weight over a larger contact area.
My car for example has four tires each at a pressure of 32 PSI. My bike, before I replaced the tires with wider tires, had two tires each at 110 PSI. Any given small patch of road I drive or ride over would only get about 29% as much force on it from the car as it would from the bike at any given time a tire is on that patch of road.
It would get that force for more time from the car than from the bike if the car is going less than ~3.4 times the speed of the bike and for less time if the car is going faster than that, and more different small patches of road would get force from the car than would get force from the bike.
This is similar to why if I were to put a flat metal plate on my chest and set a bowling ball on top it would not hurt, but if I were to set hold a dagger against my chest and set a bowling ball on top it would likely hurt a lot.
But something is wrong with my reasoning, and it turns out that road damage goes as something like the fourth power of the vehicles axel weight. Whether the tires are narrow high pressure tires or wide low pressure tires, from what I've read, is not relevant.
I'm not sure if that is because I was just wrong about top layer damage, or if it is just that lower level damage is just much more important and expensive, so any difference in top layer damage due to tire size is lost in the noise.
...
> This is similar to why if I were to put a flat metal plate on my chest and set a bowling ball on top it would not hurt, but if I were to set hold a dagger against my chest and set a bowling ball on top it would likely hurt a lot.
This is because your chest is weak and soft in comparison to the incompressible metal plate or dagger blade, which is not analogous to the situation on the road. A better analogy would be poking yourself with the tip of an al dente noodle compared to the load transmitted by a large, spongy slice of bread. Neither is going to hurt you in any way.
Whether your tire is transmitting 110 psi or 32 psi doesn't matter much because the compressive strength of Portland cement concrete is ~4000 PSI and the compressive strength of bituminous pavement is ~500 PSI.
However, soil bearing loads are on the order of 15-50 psi under constant loading, and can act as a spring or can yield at much lower transitory loads. The dirt beneath the pavement (or rather, the dirt beneath the gravel beneath the pavement) gives easily, so instead of asking the concrete to survive the compression forces caused by the contact patch, you're asking it to form a beam/plate that spreads the loads over a broad area, and asking that beam to resist deflection rather than crushing. The real damage, and the reason that damage scales with the fourth power of axle loading, is caused when a large truck rolls over the road, the ground shakes, and the roadbed flexes down into the soil under the axle and back up after it passes.
Try to imagine riding your road bike over a piece of cardboard laid on the sand. That wrinkling and creasing is much closer to actual road wear patterns than a dagger cutting your chest.
To estimate the pressure exerted on the road, you want to compare vehicle system weight/tire contact area. Velocity also plays a role.
I'd much rather get run over by average person on a bicycle than get run over by a car.
The air pressure of your car/bike tires doesn't matter - all tires could be flat. Try comparing (vehicle weight + your weight) / (vehicle contact surface area) where vehicle is either your car or your bike.
[1] http://ffden-2.phys.uaf.edu/211_fall2013.web.dir/connor_matt...
And if you notice the contact patch of a flat tire is much larger.
The ground pressure of any vehicle is almost exactly equal to the psi. With the exception of force carried by the sidewalls.
Usually it’s
* retrofitting for ADA compliance
* fixing heaving from freeze-thaw
* fixing heaving from the root systems of trees in street planters
But I could be wrong. It would be interesting to hear if heavy bike/pedestrian roads have higher road maintenance than those that are used lightly. My guess would be that the major wear and tear comes from nature, water in particular, which mean wear and tear isn't based on usage.
When it come to tire pollution those would be better taxed on the tires themselves. Bike tires tend to be much much smaller than cars so the taxation wouldn't be that big of a deal to cyclists.