Good times.
As a safety feature the car went into limp mode, limited it’s rpm and performance to less than about 40% of power and threw all the Christmas lights it could at the dash, error codes and idrive warnings.
I limped the car home and did a fault code reset from my laptop with the pirated bmw dealer software via a bluetooth-obdc2 dongle and it was fine after that.
Of course the problem continued under strenuous driving conditions. I could’ve replaced the pedal assembly but meh, it was always a good reminder to back off a bit in my 1800kg car.
It's a running joke on BMW forums, if someone throws that code most responses ask if they were driving fast and hit a pothole since that's a pretty consistent trigger.
There was often a combination of about 3-4 errors that would occur when it went into limp mode. To this day I’m not actually sure if replacing the pedal would’ve fixed it and I think off memory, it was a 220$ experiment to find out.
(On another note, make sure you’ve got the gearbox upgrade software if you haven’t already)
Fun to drive! But it required a lot more maintenance than new cars today.
After finding a good shoulder on which to beach my LTD and popping the hood, I found the problem: the socket side of the ball-and-socket throttle cable linkage had broken and would no longer hold together. Looking in my (voluminous undergrad compsci-student) trunk for a solution, my eyes landed on the -shiny- beigy PC tower, specifically the floppy drive. A couple strands of the disused 34-pin floppy cable well tied proved to be strong but flexible enough to hold that joint together and get me back to school.
Despite my college having a robust automotive program (which I even had a suitemate in), I never replaced the part and that hack held until I got rid of the car 10 years later (though I kept the other 30-odd strands of the cable in the glove box just in case).
While nostalgic, don’t read this as supportive because today I’m far more likely to find a CANBUS interface in my trunk than a floppy cable.