Re:Apache PLC4X announcing end of community support due to m...
by pjc50 on Wednesday January 12, 2022 @08:14AM
(#29905921)
The industry equivalents are probably something like MODBUS or CAN. But a kettle which has enough electronics in it to support an isolated waterproof low-voltage control connection instead of the cheap mechanical system would be significantly more expensive.
Also, nobody wants a wiring loom for their kitchen. If you have to do it, do it over zigbee or something.
Re:Apache PLC4X announcing end of community support due to m...
by p_l on Wednesday January 12, 2022 @09:03AM
(#29906395)
A lot is being done on Zigbee/Z-wave plus MQTT
Re:Apache PLC4X announcing end of community support due to m...
by ZiiS on Wednesday January 12, 2022 @06:19AM
(#29904885)
Adding physical connectors to mains voltage devices operated near water has significant costs. Wireless has managed to cater for this segment though still severely lacking standardization.
Re:Apache PLC4X announcing end of community support due to m...
by DannyBee on Wednesday January 12, 2022 @07:29AM
(#29905441)
The standard you probably want is IO-Link, or close to it.
It was meant to bring a bit of smarts to the standard 3-wire sensors and basic actuation pins, with 100% backwards compatibility.
So you have a standard analog temperature sensor that outputs 4-20ma on its pins. With IO-Link, it still does that, but if you hook it up to an io-link master, you can just read the temperature directly in C/F on the same pins. Or adjust the calibration. Or …
It's not a perfect match, mind you, but i think it's pretty close.
Re:Apache PLC4X announcing end of community support due to m...
by wiseleo on Wednesday January 12, 2022 @06:59AM
(#29905170)
I am interested in that, but my approach is more of a modchip on top of the existing board. It's not that difficult to intercept SPI and I2C in-circuit and thus enable IoT capability for legacy appliances.
Re:Apache PLC4X announcing end of community support due to m...
by Maxious on Wednesday January 12, 2022 @07:34AM
(#29905476)
There is a sort of this thing for demand response - ie. the electricity company urgently needs to reduce load and are willing to pay you for it. Of course, the appliance manufacturers have to provide a way for electricity companies that use different communication protocols to have this control.
Enter AS/NZS 4755 which uses a RJ-45 connector - if you pull the DRM1 pin to ground, the device turns off.
Re:Apache PLC4X announcing end of community support due to m...
by epaulson on Wednesday January 12, 2022 @11:56AM
(#29909359)
This is a level or two up the stack and I think it's more "meet in the cloud", but the Home Connectivity Alliance was just kicked off at CES to make appliances more interoperable:
https://staceyoniot.com/will-a-new-standard-for-smart-applia...
I would really like to see home appliance manufacturers extend their products with a simple 2.n IO pin interface at the back. Absolutely minimal. For example: a kettle could have an input pin to turn it on/off and an output pin that just writes whether it is on or not. A simple 4-pin interface on the back in this case. An ice-machine that has three size options and an on/off switch. The classic case of the bean-to-cup coffee machine.
Does anyone know if there is a standard (for manufactures) for this sort of thing? If this was a standard that added a dollar or 3 to appliances one could plug-in some IOT board that allows for Home-assistant or similar integration.
Of course I've completely ignored the question of whether or not a market exists.