The process looks like: https://www.youtube.com/watch?v=oKJagvumvCI
It is true that a boat is a curved shape (as were cars or aeroplanes before the mathematical models were devised) but the construction is quite different. To state the obvious, there are no control points. Instead you get some cross-sections for various different planes, then scale it up and manually try to achieve G2 continuity by comparing the points described in multiple places in the plan (ie in different cross sections from different but intersecting planes), adjusting them, and springing batons to create curved lines. You get different shapes depending on how thick/springy your baton is. Once more of the boat is built, the process continues with adjustments and baton-springing to try to ensure that curvature is continuous and it’s derivative is not too large.
But these plans would traditionally be produced by starting with a scale model for half the boat (often this model would be scaled up straight into the boat without plans in between). And traditional boat building (say 100 years ago) would often not be particularly true to the plans anyway, treating them much more as a guide (a case where this matters more is some of the traditional steel shipbuilding in Scotland where the yards were too small so boats were built in two halves then perfectly joined together at the end).
Now compare this to the OP which is about various mathematical models for curves and surfaces, and the comments above which talk about the history of those models. I think the automaker usage described above was about the problem of going from the computer-described curves to the real world and I guess CNC at the time couldn’t do it properly (you surely aren’t going to CNC-mill a car model out of a massive block of metal) hence transforming a computer description into something suitable for a physical model—fixed lengths of spring steel plus weights. Spring steel sounds a bit like springing batons but I think that is where the connection ends and I think this connection has little to do with the rest of this reply chain.
Though to be honest I’m not particularly sad that you posted it.
But they did use physical splines to draw smooth curves long before car/airplane designers.
In computer software, bezier curves have always been common in 2d desktop publishing (fonts, adobe illustrator and its predecessors etc.) but 3d software had an ambivalent relationship where animation software (3DS-max etc.) always used them but games avoided them due to higher computation time than straight meshes, hence lower framerates. Of course this is changing now.
https://www.youtube.com/watch?v=c0_a6r2JaWQ
they'd be surprised
Sources:
http://mae.engr.ucdavis.edu/~farouki/bernstein.pdf Wikipedia
(edit: Mercedes-Benz)
Like, the control points on splines were called "ducks", which were weights attached to spring steel suspended from the ceiling of the studio, which caused the steel to bend into particular shapes computed mathematically beforehand by the design engineers. These curves were used to guide model making. It was a fascinating book.