News for hackers. Stuff that matters.
Re:Introducing raspberrypi.com by HideousKojima on Wednesday October 06, 2021 @11:20AM (#28774211)
Basically this list of known working adapters is your best bet: https://jamesachambers.com/raspberry-pi-4-usb-boot-config-gu...

You can technically just disable UAS like you said, but you'll likely lose some drive performance. But if filesystem corruption is a concern then you're probably safer disabling it.

Re:Introducing raspberrypi.com by scottlamb on Wednesday October 06, 2021 @01:50PM (#28776045)
I don't think that list is good enough. I've had adapters work fine for months with UAS and then have errors. I went through a few rounds of that, disabled UAS, and haven't had problems with the same adapters for a couple years since. So I believe there are adapters out there that more or less work with UAS on Linux but under some infrequent condition (likely load-related) cause these sorts of errors. So a table of "Known Working Adapters" with notes like "Reported as working with UASP support by pierro78 in the comments" doesn't address my concern.