Re:Introducing raspberrypi.com
by HideousKojima on Wednesday October 06, 2021 @11:20AM
(#28774211)
Basically this list of known working adapters is your best bet: https://jamesachambers.com/raspberry-pi-4-usb-boot-config-gu...
You can technically just disable UAS like you said, but you'll likely lose some drive performance. But if filesystem corruption is a concern then you're probably safer disabling it.
I don't think that list is good enough. I've had adapters work fine for months with UAS and then have errors. I went through a few rounds of that, disabled UAS, and haven't had problems with the same adapters for a couple years since. So I believe there are adapters out there that more or less work with UAS on Linux but under some infrequent condition (likely load-related) cause these sorts of errors. So a table of "Known Working Adapters" with notes like "Reported as working with UASP support by pierro78 in the comments" doesn't address my concern.
How does one do that? I've been bitten with block-level and then filesystem-level errors, so I just recommend always disabling UAS. [1] But if you have a good way to make sure UAS is fully reliable, I'd love to update my recommendation.
[1] https://github.com/scottlamb/moonfire-nvr/wiki/System-setup#...