Since switching to that grade of service I have consistently had captcha challenges every time I go through paypal (despite it saying 'we recognise you on this device...'), my Unifi VPN fails to work, despite following several guides specifically for double NAT (I'll probably end up with wireguard), and most recently my O365 endpoint failed to talk to me, as one of the half-dozen IPv4 addresses they route out of had been marked by Spamhaus.org, which a) is identified a woeful arrangement in itself, and b) took me two days to get rectified by the ISP by switching which address I came out with (a minor change which resulted in a 24 hour total outage).
I did ask about IPv6 - but nothing about that experience screamed 'we're ready to move our customers to IPv6', as you could imagine.
… but I believe they heavily filter the traffic in said IPv6 network, so that the addresses are not reachable
Ouch. I hope that's something they can work on with the next version of the ground terminal. Do they at least start up quickly when powered down?
You have hundreds of tiny antennas using constructive and destructive interference to steer the signal in software.
This digital aiming is awesome for targeting fast moving objects in low earth orbit. But you lose the huge amplification factor possible with a simple metal dish.
Combine this with the the desire to use higher attenuation frequencies in order to increase throughput and I don't really see Starlink's power consumption going down.
That power budget already represents a pretty big victory, and any gains will probably go to lower unit cost or higher data rates.
It doesn't. It moves to be in the same plane as the satellite, but it doesn't actually track the satellite.
The phased array can only track a single line across the sky. The dish moves so that line is parallel with the satellites orbit.
But after an initial aiming, the motors basically lock in place and the dish stays still. The phased array then tracks individual sats in orbit.
I'm barely hitting 1GB / month of metered content (but doing 300-600gb of unmetered) which is a huge improvement over the similar-priced satellite plans from SkyMesh for 70/70 (peak & off peak) plans, which involved regular usage checks and much fretting over bandwidth utilisation.
I think you parsed it correctly - author is saying you can’t get away from 600ms latency and limited bandwidth given where they live.
NBN (Australia's national broadband system) introduced, via a partner, this Sky Muster Plus offering about two years ago, that includes effectively unmetered plans, so the claim isn't as true as it used to be.
I'm not sure how that sentence is meant to be parsed, but the NBN Sky Muster Plus packages include unlimited downlink traffic (for everything except streaming video), though of course you're always stuck with satellite latency at ~ 600ms to domestic services ... at least until Starlink saves us all.
Though the Starlink phased arrays apparently consume a fairly consistent 100W, which might kibosh these kinds of cheap and cheerful solar + car battery rigs.
Plus I've not seen what Starlink offers in terms of fixed IP, or at least inbound routing. I can confirm that NBN SMP (as above) while relatively cheap for those of us in the middle of nowhere, does suffer from CGNAT, which makes this kind of self-hosted service infeasible.