News for hackers. Stuff that matters.
Re:The Polar Bear – Open-Source, Multipurpose CNC Machine wi... by prova_modena on Thursday August 19, 2021 @01:16PM (#28236555)
There are some industrial machines that compensate for chatter by slightly varying the spindle speed when chatter is detected. However machines so equipped are fundamentally very rigid and usually experience chatter occurs when pushing end mill performance to its limits. I suspect the adaptive spindle speed strategy would be much less useful on a machine like the Polar Bear.
Re:The Polar Bear – Open-Source, Multipurpose CNC Machine wi... by jjoonathan on Thursday August 19, 2021 @04:12PM (#28238758)
Right, resonance dodging and deflection compensation aren't going to cut it here, not by a long shot. I still think a sufficiently good 5 axis control loop could damp acoustics: for one, the (fractional) millisecond timescale of the acoustic oscillations are geological by compute standards, and while I'd expect limitations from sensing, actuation, and power electronics, I don't see anything fundamentally prohibitive. I'm pretty sure this is an engineering problem, not a physics problem, and that eventually someone is going to crack this nut. It won't be the Polar Bear.