Though too be fair, I think the low power mode wasn't signaled by a black image but instead turning off the sync signals or something like that. (I hope you get the idea that I don't know how it worked here)
Same thing with switching monitors off after work.
Though same screensavers would run for a while and then switch the monitor to power saving mode, effectively turning it off.
In the early 1990s, there was no power saving. You could turn off the monitor with the front power switch, or use the screensaver.
A few years later, power saving options began to be introduced. The computer could signal to the monitor that it should go into a low(er) power state. Turning on again took at least 5 seconds for a visible picture, sometimes 15-20. That might not be appropriate if the computer had to be used in response to something like a phone call, or visitor at reception.
The screen is charged. That charge causes burn in. The best way to not burn in, short of turning the screen off, is to charge the screen as little as possible. The least charge you can give it is a black signal, which means least burn in.
The point is that you could not give it no signal without it being off. LEDs can do this. The closest to black from a CRT I saw was from Sony's Professional Studio reference monitors that were $32K for a 32" screen. When Sony brought out their OLED reference monitors, they did a side-by-side comparisson of their best CRT, an LCD and the new OLED. All 3 were receiving the same signal, and when the demo started black, the CRT was clearly "on" but the OLED looked "off" with the LCD in between. Just about the time I'm thinking to myself that the CRT brightness was turned up, they switched to reference bars and all were calibrated correctly.
Arguing that CRTs could display true black is arguing against history.
If you can't or don't want to turn you CRT off... then what's the next best thing for avoiding burn-in?
Send it a black signal, or send it a bright signal?
It's the black signal, because it charges the screen less. Charging the screen is what causes burn in. If you charge it less you get less burn in.
> Arguing that CRTs could display true black
Nobody argued this. Where did you think you read this? I said 'show a black image'. Send it a black signal. It's the minimum signal you can send it without turning it off.
Why didn't we just show a black image?