News for hackers. Stuff that matters.
Re:Thinkpad X230 with “e-Ink” display at 30fps [video] by fortran77 on Monday April 19, 2021 @08:32PM (#26869422)
Nothing? What about the cheap and powerful single board controllers?
Re:Thinkpad X230 with “e-Ink” display at 30fps [video] by Miraste on Monday April 19, 2021 @09:08PM (#26869679)
You'd think so, and some printers like the Prusa Mini use newer 32-bit controllers, but a lot of the most popular models (other Prusas, most Creality models, etc.) use the ATmega 2560, which is an 8 bit controller that came out in 2006 and isn't much different from what was available in the late 90s. They didn't exist in 1989, but they weren't far off.
Re:Thinkpad X230 with “e-Ink” display at 30fps [video] by monocasa on Tuesday April 20, 2021 @01:07AM (#26870894)
Oh, we for sure had 8 bit microcontroller chips in 1989. A quick look back through old editions of Radio Electronics looks like you could buy an 8039[0] in 1989 for $1.95 qty 1. PICs were pretty nice back then too.

[0] - An 8039 is a version of the 8048 that was in the original PC keyboard, but rigged up with an external EEPROM for program code instead of the normal mask ROM. They were probably secretly 8048s that were programmed with some other customer's code in the mask ROM, but then fused off for whatever reason.

Re:Thinkpad X230 with “e-Ink” display at 30fps [video] by hakfoo on Monday April 19, 2021 @11:00PM (#26870243)
Even if you didn't have a free-standing cheap microcontroller, couldn't you do a "Winmodem" style scenario where the printer is a bag of dumb mechanical bits tethered to a PC doing all the heavy lifting in software?
Re:Thinkpad X230 with “e-Ink” display at 30fps [video] by rasz on Tuesday April 20, 2021 @01:39PM (#26877825)
You will like 1987 Atari SLM605/SLM804 Laser printers. They had no electronics inside other than the power supply. Instead a dongle was shipped with 19pin Atari ST DMA port (ASCI, very similar to SCSI) on one end, and 37 pin connector for the printer on the other. It contained two microcontrollers, Intel 8253 timer chip, Toshiba TC9142P dedicated Direct Drive Turntable motor controller :), bunch of buffers and some chips I cant identify.

https://manualzz.com/doc/7345398/atari-slm804-service-manual...

Unlike all the other printers up to late nineties there was no high level computing smarts neither in the printer nor in the dongle. It was a Software Defined printer fully controlled by Atari ST (computer UI froze during printing to maintain tight timings), just like post year 2000 HP LaserJet 1000 and later Windows "host based" non PCL printers. As a result of this Atari ingenuity you ended up with a combo of Atari ST computer, 640×[email protected] Hz monitor, DTP software (for example Calamus) and a Laser printer costing less than just the Apple or IBM laser printer alone, and as a bonus it printed 2-3 times faster.

So yes, 3D FDM printer at reasonable price was totally possible in late eighties leveraging cheap 16bit computers for control logic.